ASSEMBLY
Installing clear hose to water connection
See Figure 10, page 20.
Attach the clear hose into the water supply valve con- nection on the inside of the water tray.
tile cutting wheel
For maximum performance and safety, it is recommended that you use the 7 in. cutting wheel provided with your saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no load speed of this tool. Failure to heed this warning could result in personal injury. Do not use wheel with cracks, gaps, or teeth.
WARNING:
To prevent possible electrical hazards, have a qualified electrician check the line if you are not certain that it is properly wired.
Installing TILE CUTTING WHEEL
See Figures 11 - 13, page 20.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel capacity of the saw. Never use a wheel that is too thick to allow wheel washer to engage with the flats on the spindle. Larger wheels will come in contact with the wheel guard, while thicker wheels will prevent the wheel bolt from se- curing the wheel on the spindle. Either of these situations could result in a serious accident and can cause serious personal injury.
Unplug the saw.
Loosen the wheel guard lock.
Rotate wheel guard back to expose the arbor nut.
Fit the wheel wrench on the arbor nut then the hex key in the spindle.
Holding the hex key in place to prevent the wheel from moving, turn the arbor nut counterclockwise. Remove the hex key, wheel wrench, arbor nut and outer washer. Do not remove the inner washer.
Wipe a drop of oil onto inner washer where it contacts the wheel.
WARNING:
If inner washer has been removed, replace it before placing wheel on spindle. Failure to do so could cause an accident since the wheel will not tighten properly. Never use wheels that have openings, grooves, or teeth on this tool.
Place the cutting wheel onto spindle.
Replace outer blade washer. The double “D” flats on the blade washers align with the flats on the spindle.
Using hex key and wheel wrench, tighten arbor nut securely.
Retighten the wheel guard lock securely.
Installing the rip guide
See Figure 14, page 21.
Place the rip guide in the unlocked position (lever up).
Fit the rip guide onto the permanent fence on the Easy Glide Table™.
Lock the rip guide in place by pushing the lever down.
Installing the bevel block
See Figure 15, page 21.
Place the bevel block in the unlocked position (lever up).
Fit the bevel block tab into the slot and onto the perma- nent fence on the sliding table.
Lock the bevel block in place by pushing the lever down.
NOTE: The bevel block should only be used on the right side of the Easy Glide Table™.
connecting garden hose to the tile saw
See Figure 16, page 21.
The water supply must come from a fresh water main. NEVER turn the water supply on high.
Uncoil the garden hose.
With the water main faucet turned completely off, attach the end of the garden hose to the water supply valve. Tighten by hand.
Secure hose to the water tray as shown.
The water supply valve provides a convenient on/off for starting, stopping, and adjusting the water flow onto the wheel. When used properly, the water supply valve adjusts the water flow to the perfect, optimal rate.
11 — English