Features, Position of the Tile saw

ELECTRICAL

If the saw is used with an extension cord, ensure the con- nection of the tool’s power cord and the extension cord are not on the ground.

If a protected outlet is not available, do not use the saw until an outlet can be changed or auxiliary protection can be obtained. These auxiliary protection devices are available at your local retailer.

below the level of the outlet, or the connector if an extension cord is used, to prevent water traveling along the cord and coming in contact with the outlet.

If the plug or outlet does get wet, DO NOT unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the tool then unplug and examine for the presence of water in the outlet.

POSITION OF THE TILE saw

See Figure 2, page 17.

To avoid the possibility of the tool plug or outlet getting wet, position tile saw to one side of a wall-mounted outlet to prevent water from dripping onto the outlet or plug. The operator should arrange a “drip loop” in the cord connecting the saw to the outlet. The “drip loop” is that part of the cord

WARNING:

To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with wet hands.

FEATURES

PRODUCT SPECIFICATIONS

Blade Diameter	7 in.
Blade Arbor	5/8 in.
Throat Capacity	9-1/2 in.
Rip Capacity (tile size)	16 in.

KNOW YOUR tILE saw

See Figure 3, page 18.

The safe use of this product requires an understanding of the information on the tool and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules.

7 in. Tile CUTTING wheel - A 7 in. tile cutting wheel is included with your saw.

WARNING:

Do not use wheels rated less than the speed of this tool. Failure to heed this warning could result in personal injury.

BEVEL BLOCK - Bevel block supports tile for fast, clean, and consistent 45º edges.

NOTE: Only use bevel block on the right-hand side of the table.

Diagonal Capacity (tile size)	........................................12 in.
Maximum Depth of Cut	2-1/4 in.
Rating	120 V~, 60 Hz, 9 Amps
No Load Speed	5,800 r/min. (RPM)

CLEAN WAVE WALL™ - If you purchased the optional pump,

the Clean Wave Wall™ system helps prevent sediment from entering the pump to extend pump life.

NOTE: Optional pump sold separately.

easy glide table™ - For precise and accurate cuts.

END-OF-CUT REMINDER - End cut reminder prevents chips and broken tiles by slowing down the Easy Glide Table at the end of a cut. Also acts as hose holder.

FLOW ADJUSTMENT VALVE - Turns water flow to the cut- ting wheel either on or off. When used with the optional water pump, this feature becomes a variable flow adjustment.

MOTOR - This machine has a strong motor with sufficient power to handle tough cutting jobs. It also has externally accessible brushes for ease of servicing.

ON/OFF SWITCH - This saw has an easy access power switch located below the front rail. To lock the switch in the OFF position, remove the switch key from the switch. Place the key in a location that is inaccessible to children and oth- ers not qualified to use the tool.

9 — English