Instructions
About the controls on the air
Appearance may vary.
and Cleaning Operating Instructions Safety
Cool
| Fan |
Timer | High |
On | Med |
|
Low
TimerSleep
On
Off
Air Conditioner Controls
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
Controls
Remote Control
When the air conditioner is turned on, it will automatically start in the setting last used.
Support Troubleshooting Tips Installation Instructions Care
ON/STOP
Turns air conditioner on and off.
Display
MODE
On the remote control, use to set the air conditioner to COOL or FAN mode.
On the air conditioner controls, use to set COOL or FAN mode at HIGH, MED or LOW fan speed. Indicator lights on the air conditioner controls will show the mode and fan speed selected.
TEMP Increase ▲ /Decrease ▼ Pads
Use to set temperature when in COOL mode.
Fan Speeds (Remote control only)
Use to set the fan speed at LOW, MED or HIGH.
TIMER
To cancel (CL) the On Timer press the ON pad again.
To cancel (CL) the Off Timer press the OFF pad again.
To cancel the timer, press the ON or OFF pads until the display time disappears.
SLEEP
Press to set the air conditioner to run for 8 hours before it automatically returns to the previous setting.
When the sleep timer is set, the set temperature will automatically increase 2°F after the second hour then 1°F each hour over the next two hours.
To cancel the sleep mode, press the MODE pad or the SLEEP pad a second time.
Remote Control Signal Receiver
Consumer
| Remote Control |
| ■ To ensure proper operation, aim the |
| remote control at the signal receiver |
| on the air conditioner. |
4 | ■ The remote control signal has a range of |
up to 21 feet. |
■Make sure nothing is between the air conditioner and the remote control that could block the signal.
■Make sure batteries are fresh and installed