GE DCB AJCS 06, ACB AJCQ 10, ACB AJCS 12 DCB Temperature Limiting, Cleaning Installation

Page 9

www.GEAppliances.com

Fan Switch

To reach the fan switch(es) remove the front grille.

Safety Instructions

On Heat/Cool and Heat Pump models, the fan switch levers are located in holes accessed through the control box. The top switch is for COOL settings and the bottom switch is for HEAT settings.

Use a small screwdriver to change the setting. The unit is shipped from the factory set in the CONT setting for COOL and in the CYCLE setting for HEAT.

or

(Depending on model)

Operating

Cool only models have a rocker switch on the front of the control box.

When set at CYCLE (down) the fan cycles on and off when cooling. When set at CONT (continuous, up) the fan runs all the time, providing a more balanced temperature. The unit is shipped in the CONT setting.

Instructions Care and

Temperature Limiting

Limiting the maximum and minimum settings prevents users from turning the control to the extreme heat or cool positions.

The normal range of the temp control is approximately 60°F to 85°F. The control range may be narrowed by the use of the temperature limiting screws located behind the control panel.

Limits

Limits

heat

cool

temp

temp

Cleaning Installation

Each position equals approximately 3°F.

Vent Control

The vent control is located behind the front grille on the right side of the air discharge area. When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.

To open or close the vent:

1.Remove the front grille.

2.Remove the vent card screw.

3.Remove vent card, turn it over and replace it by locating rear hole in card over locating pin inside air discharge and reattaching screw at front.

The unit leaves the factory set at the CLOSE position.

Locating hole

Locating hole

Screw hole

Screw hole

OPEN position

CLOSE position

(Mesh end toward back)

(Mesh end toward front)

Instructions Troubleshooting Tips

Air Direction

Horizontal louvers

Remove the front

 

on the front grille

grille to adjust the

 

let you control the

vertical louvers

 

air direction up

side-to-side to

 

and down.

direct the air left

 

 

or right.

9

 

 

Consumer Support

Image 9
Contents Serial # Write the model and serial numbers hereInstructions Care and Cleaning Operating InstructionsOperating Instructions Tips Consumer SupportCare Instructions Consumer Remote ControlFan Switch SafetyTroubleshooting Tips Air Direction Vent ControlAuxiliary Controls Temperature Limiting Page Cooling/Heating Descriptions Mode ControlHeat Pump Models Temp ControlCleaning Installation Temperature LimitingCleaning Operating Instructions Safety Instructions Care and cleaning of the air conditionerGrille and Case Outdoor CoilsAir Filter How to Insert the BatteriesBefore YOU Begin Electrical RequirementsModel Qualifying Questions GE KIT Numbers Tools YOU MAY NeedAttach Front Grille Installing a J-MODEL in AN Existing Wall CaseInstalling Through the Wall Prepare Opening in WallSupport Requirements for AIR Conditioner Window Requirements Window INSTALLATION-OPTIONALWood Pieces Width 2″ Storm Window RequirementsPrepare Window Install Sill SupportsRight Left MEASURE, CUT and Install Filler PanelsInstall Case in Window Replace AIR Conditioner in Case Install Window Gasket and Locking BracketConsumer Support Normal Operating Sounds Before you call for service…Troubleshooting Tips Consumer Support Air Conditioner WarrantyGE Will Replace For The PeriodInstructions de sécurité Instructions de fonctionnement Avertissement Nettoyage Cas de panne Instructions de montage Entretien etTélécommande Sécurité Consommateur En cas de panne Commande d’éventInterrupteur du ventilateur Direction de l’airCommandes auxiliaires Limitation de température Commande de la température Commande du modeDe sécurité Instructions de montageDirection de la sortie d’air Limitation de la températureGrille et boîtier Entretien et nettoyage du conditionneurSerpentins extérieurs Pour retirerMise EN Garde Ne faites Filtre à airComment insérer les piles Exigences EN Matière ’ALIMENTATION Électrique Avant DE CommencerNuméros DE Trousses GE Outils Dont Vous Pouvez Avoir BesoinGlissez Délicatement LE Conditionneur Dans LE Logement Retirez LA Plaque DE Verrouillage SUR LE Côté Gauche Avant’AIDE D’UNE Agrafe Fixez LA Grille FrontaleInstallation À Travers LE MUR Préparation DE L’OUVERTURE Dans LE MURSupport DU Conditionneur Instructions Relatives À LA Fenêtre Installation DE Fenêtre EN OptionRetirez LE Conditionneur DE SON Logement Instructions Relatives À LA CONTRE-FENÊTREPréparez LA Fenêtre Installez LES Supports DE SeuilMESUREZ, Coupez ET Installez LES Panneaux DE Fermeture Montez LE Logement Dans LA Fenêtre Replacez LE Conditionneur Dans SON Logement Bruits normaux de fonctionnement Avant d’appeler le serviceNous remplacerons Garantie du conditionneur d’airCe qui n’est pas couvert Et nettoyage Instructions de montage EnService de réparations Soutien au consommateurProlongation de garantie Serie No Cuidado y limpiezaCuidado y limpieza Apoyo al consumidor Solucionar problemasPrecaución Limpieza Instalación Solucionar problemasControl remoto Control remotoLimpieza Modo FAN Ventilador Interruptor del ventiladorControl del escape Dirección del aireControles auxiliares-Limitación de temperatura Apoyo al consumidor Solucionar problemas InstalaciónNotas Control de la temperatura Descripciones de enfriamientoModelos con bomba de calor Para calefacción máxima SeleccioneDependiendo Del modelo Límite de la temperaturaRejilla y caja Cuidado y limpieza del acondicionador de aireBobinas exteriores Rejilla delanteraPrecaución No opere el Filtro de aireCómo insertar las baterías Requisitos Eléctricos Antes DE IniciarNúmeros DE KIT DE GE Herramientas QUE Podría NecesitarUNA LA Rejilla Delantera Cómo Instalar UN Modelo J EN UNA Caja DE Pared ExistentePrepare LA Abertura DE LA Pared Cómo Instalar a Través DE LA ParedRequisitos Para EL Apoyo DEL Acondicionador DE Aire Requisitos DE Apoyo Para EL Acondicionador DE AireRequisitos Para LA Ventana Instalación DE VENTANA-OPCIONALRetire EL Acondicionador DE Aire DE LA Caja Requisitos DE Ventana Para TormentaInstale LOS Soportes DE LA Alfajía Exterior Prepare LA VentanaCentro MIDA, Corte E Instale LOS Paneles DE RellenoInstale LA Caja EN LA Ventana Reemplace EL Acondicionador DE Aire EN LA Caja Instale EL Empaque Para LA Ventana Y EL Soporte DE BloqueoSonidos de operación normales Antes de llamar para solicitar servicio…Notas Limpieza Garantía de su acondicionador de aireNosotros reemplazaremos Lo que no está cubiertoSolicite una reparación Apoyo al Consumidor Página Web de GE AppliancesGarantías ampliadas Piezas y accesoriosParts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio