Genie 1042 manual Securely fasten wires, Do not install rear cover yet, Mounting

Insulated

Staple

3.Securely fasten wires.

•Securely fasten wires to ceiling and wall using insulated staples provided.

– Use insulated staples.

– Staples should be snug only.

• If rear cover is attached to power head, remove it.

•On power head:

–Route Wall Button wires through wire guide.

–Split and strip ends of wire (Fig. 3-2 on previous page).

–Insert wire into terminal holes and lightly press in the orange locking clips above each terminal hole. (You can use a pencil or small screwdriver to comfortably press in locking clips.) The white wire into #1 terminal hole and striped wire into the #2 terminal hole.

–Confirm wire lock by lightly tugging on the wire. The wire should remain in the terminal hole.

•Do NOT install rear cover yet.

Locking
	Clips				Terminal
					Holes
6	5	4	3	2	1
					6	5	4	3	2	1
									+ –
									P	B
					InfaredSensor

(Power Head With Rear Cover Removed) FIG. 3-3 Insert wires.

4.Mounting.

• Fasten Wall Button to wall with 2 screws

(provided) (Fig. 3-4).

• Remove protective backing from "Entrapment" warning label (Fig. 3-5). The "Entrapment" label is located in the center of this manual.

– Stick label on wall near Wall Button.

FIG. 3-4 Mounting Wall Button.

FIG. 3-5 Mounting Entrapment warning label.

16 PN# 36420Supplement, 10/27/2008