Additional Drying Heat, Models With An LED Display

Power Regular Delicate

Scrub Wash /Econo

Plus

Cancel Drain

Figure 28/Ilus. 28

Figure 29/Ilus. 29

E n g l i s h

(Special Features, continued)

Changing the Cycle Completion Signal

Volume

Models With No LED Display:

1.Open the dishwasher door far enough to expose the control buttons.

2.Press and hold down the right-most of the two buttons labelled “Cancel Drain”, as shown in Figure 28, then press and hold the On/Off button. When the light on the “Cancel Drain” button you are pressing illuminates, and the tone begins to sound, release both buttons.

3.Press the “Cancel Drain” button you previously pressed until the tone is at the desired volume, or until it is silent.

4.Press the On/Off Button.

5.Close the dishwasher door. The Cycle Completion Signal is now set, and you may wash your dishes as usual.

Models With An LED Display:

1.Open the dishwasher door far enough to expose the control buttons.

2.Press and hold down the Delay Start Button, then press and hold the On/Off button. When the tone begins to sound and the display shows a 0, 1, or 2 , release the buttons.

3.Press the Delay Start Button button until the tone is at the desired volume, or until it is silent. The display will show a 0, 1, or 2 for the volume level.

4.Press the On/Off Button.

5.Close the dishwasher door. The Cycle Completion Signal is now set, and you may wash your dishes as usual.

Additional Drying Heat

With this special feature you can raise the temperature of the rinse water, which will result in better condensation drying.

Front Control

1.Press and hold the left-most of the two buttons labelled “Cancel Drain”, as shown in Figure 29, then press and hold the On/Off button. When the LED display shows a “0” or a “1”, release both buttons. The light above the left-most “Cancel Drain” button will begin to flash.

2.Press the left-most “Cancel Drain” button until the LED display shows a “1”, indicating that the Additional Drying Heat is enabled.

3.If you wish to disable the Additional Drying Heat, press the left-most “Cancel Drain” button again. The LED display will show a “0”, indicating that the Additional Drying Heat is disabled.

4.Press the On/Off button. The light above

the left-most “Cancel Drain” button will stop flashing. You may now wash dishes as usual.

36 Special Features Caractéristiques Spéciales Caractísticas Especiales