E n g l i s h
(Operate the Controls, Continued)
Top Control
1.Open the dishwasher door far enough to expose the control buttons.
2.Press the On/Off button.
3.Press the button for the wash cycle desired.
4.Close the dishwasher door and make sure it is securely shut.
5.The dishwasher will start and automati- cally continue operating until the end of the selected cycle.
WARNING: YOU COULD BE SERIOUSLY SCALDED IF YOU OPEN THE DISHWASHER DOOR QUICKLY DURING A WASH OR RINSE CYCLE. ALWAYS WAIT AT LEAST 10 SECONDS (OR UNTIL WATER NOISES STOP) BEFORE FULLY OPENING THE DISHWASHER DOOR.
Once you start the dishwasher, leave the dishwasher door shut until it finishes the cycle. At the end of the cycle the dishwasher will stop. Depending on the model of dishwasher you have
•the “Clean” light will illumninate,
•the LED display will show “0”,
•the dishwasher will beep
•the “Sanitized” light will illuminate
When the “Sanitized” light illuminates, it means that the wash cycle has met very strict requirements of time and temperature for certification as “Sanitized” by the National Sanitation Foundation. For more information on this certification, turn the section titled “The NSF Symbol” on page 7 in this manual.
Interrupting, Changing, and Cancelling Cycles
As a safety feature, the dishwasher will automatically turn itself off whenever the door is opened.
Interrupting a Cycle
Front Control
1.Press the On/Off button to stop operation.
2.Wait at least 10 seconds (or until water noises stop) before opening the door.
3.To resume the cycle, close the dishwasher door and push the On/Off button
(Continued On Next Page)
28 | Operation Fonctionnement Operación |