Figure 27/Ilus. 27
E n g l i s h
(Special Features, Continued)
Delay Start
This feature allows you to delay the start of the selected wash cycle for up tp 19 hours.
Front Control
1.Press the On/Off Button
2.Press the Delay Start button. Continue
pressing the Delay Start button until the LED display shows the number of hours of delay you desire.
3.Press the button for the desired wash cycle. You can change the cycle at any time during the delay.
Top Control
1.Open the dishwasher door far enough to expose the control buttons.
2.Press the On/Off Button
3.Press the Delay Start button. Continue
pressing the Delay Start button until the LED displays shows the number of hours of delay you desire.
4.Press the button for the desired wash cycle. You can change the cycle at any time during the delay.
Top Rack Only™ Cycle
This cycle allows you to save energy, water, and detergent by washing loads small enough to fill only the upper rack. Note: The Top Rack Only cycle does not reduce wash time.
To use the Top Rack Only Cycle:
1.Load the upper rack. Figure 27 shows a typical mixed load placed correctly in the upper rack.
2.Press the On/Off button.
3.Press the button for the desired wash cycle.
4.Press the Top Rack Only button.
OptiMISER™
This feature, used in conjuncton with the other wash cycles, reduces wash time by about 30%. NOTE: OptiMISER™ is NOT used with the Quick Wash or Rinse and Hold cycles.
To use OptiMISER™:
1.Press the On/Off button.
2.Press the desired cycle selection button.
3.Press the OptiMISER™ button.
Cycle Completion Signal
This feature is a tone that sounds when your Siemens dishwasher finishes washing and drying your dishes, and is available ONLY on Top Control models. You can either disable the tone, or you can set it at one of two volumes (dishwashers with this feature leave our factory with the tone set on the lowest volume).
(Continued on Next Page)
34 Special Features Caractéristiques Spéciales Caractísticas Especiales