Murray 11052x4D manual Ment spark plug, Filter cover and the air filter

Page 17

MAINTENANCE

SPARK PLUG	3. Before installing the spark plug, coat
	the threads lightly with oil for easy re-
Check the spark plug every 25 hours. Re-	moval. Tighten the spark plug to a torque
place the spark plug if the electrodes are	of 15 foot-pounds.
pitted or burned or if the porcelain is
pitted or burned or if the porcelain is
cracked.	Feeler Gauge
	0.035”

1.Make sure the spark plug is clean. Clean the spark plug by carefully scrap- ing the electrodes (do not sand blast or use a wire brush).

2. Check the spark plug gap with a feeler
gauge. See “Product Specifications” for	Spark Plug
the correct spark plug gap and replace-	Figure 11
ment spark plug.	Figure 11

HOW TO CLEAN THE AIR FILTER

The engine uses a foam air filter that can be cleaned and reused. Clean and oil the air filter every 25 hours. Clean more often in dusty conditions. Remove and clean the air filter as follows:

CAUTION: Never run the engine without the air filter installed. An air filter clogged with dust can result in loss of engine power and can cause excessive wear or damage to the engine. If the air filter is clogged, clean or replace immediately.

1.	Disconnect the spark plug wire from the
	spark plug.
2.	Remove the screws from the air filter
	cover (see Figure 12). Remove the air
	filter cover and the air filter.
3.	Wipe the cover and the inside of the air
	filter housing with a clean cloth.
4.	Clean the air filter in a solution of water
	and household detergent. Rinse tho-
	roughtly in clean water.

6.Cover the outside of the air filter with oil. Use the same type of oil as used to make the fuel mixture. Lightly squeeze the air filter to distribute and remove any excess oil.

7.Put the clean air filter into the air filter housing.

8.Install the air filter cover and secure with the screws as shown.

9.Connect the spark plug wire to the spark plug.

Air Filter

Cover

5. Wrap the air filter in a dry clean cloth.

Filter Housing

Screw

Squeeze out (do not twist) all solution

until dry.

Figure 12

CYLINDER EXHAUST PORTS

Clean the cylinder exhaust ports after every 75 hours of operation. For this procedure, we recommend that you take your unit to a Au- thorized Service Center.

F-031306L

17

Image 17

Contents Cultivator MURRAY, INC. Two Year Limited Warranty Responsibility of the Owner OWNER’S InformationFuel Safety Safety RulesOperating Safety Safe Operation Practices for CultivatorSafe Storage Repair / Adjustments SafetySlow Fast Fuel Oil Choke OFF Half Choke Full Choke International SymbolsAssembly Parts Packed Separately in Carton AssemblyHOW to Remove the Cultivator from the Carton HOW to Assemble the HandleDle and damage the engine casing Outside of the lower handle as youTighten the knobs Checklist EYE Protection OperationKnow Your Cultivator HOW to Operate the Cultivator HOW to USE the CultivatorHow To Stop The Cultivator How To Set The DepthBefore Starting the Engine How To Prepare The EngineHow To Mix The Fuel Mixture No Choke Half Choke Full Choke Choke Control HOW to Start the EngineThese areas Cultivating Tips Hints for Depth Stake or Wheel AdjustmentSeed bed preparation 4 to 6 inches depth Heavy soil 4 inch depth or greaterProduct Specifications MaintenanceCustomer Responsibilities General RecommendationsRemove the air vent screw see Figure LubricationFilter cover and the air filter Ment spark plugHOW to Remove and Install the Tines Service and AdjustmentTine Installation Tine RemovalEngine Shown With Air Filter Removed HOW to Adjust the CarburetorEngine StorageCultivator Trouble Cause Correction Trouble Shooting ChartModel 11052x4D KEY 482 483 480 485 484 493 481 490 496 492 660 650 661 662 663 946 950930 948 943 MURRAY, INC. Lawn Mower Central Parts Distributors HOW to Order Repair Parts031306L MURRAY, INC. Garantie limitée de deux ans Responsabilités DU Propriétaire Informations S’ADRESSANT À L’USAGERRègles de sécurité pour l’utilisation de la motobineuse Règles DE SécuritéAvant toute utilisation Précautions pour le carburantSécurité des réparations et du régla- ge Sécurité d’entreposageÉloignez toute personne De la zone de travail Lent Rapide CarburantStarter fermé Mi-starter Plein starter Montage Pièces Emballées Séparément Dans LE Carton MontageDéballage DE LA Motobineuse Montage DES ManchesInsérez le manche inférieur gauche Montez la commande des gaz sur leDans la colonne de montage voir Les contre-écrous comme indiqué à laListe DE Vérification Connaissance DE LA Motobineuse UtilisationProtection DES Yeux Interrupteur MARCHE/ARRÊT LaConduite DE LA Motobineuse Mode D’EMPLOI DE LA MotobineuseArrêt de la motobineuse Réglage de la profondeurPréparation du moteur Avant DE Démarrer LE MoteurComposition du mélange de carburant Lange dosage 24Que le moteur a tourné. Évitez de toucher ces pièces Starter fermé Mi-starter Plein starter Commande du starterDémarrage DU Moteur Terre forte 10 cm ou plus de profon- deur Conseils Pour LE LabouragePréparation du sol pour semis de 10 à 15 cm de profondeur Entretien Recommandations GénéralesResponsibilités DE L’ACHETEUR Caractéristiques ProduitRemontez la vis de purge d’air Retirez la vis de purge d’air voir FigureTre à air et le filtre à air Placement de la bougieDémontage ET Montage DES Lames Entretien ET RéglageDémontage des lames Montage des lamesRéglage DU Carburateur Motobineuse EntreposageMoteur Panne Cause Réparation Tableau DE DepannageChesapeake Ave. Columbus, OH 614488−7951 Commande DE Pièces Détachées031306L Garantía Limitada de Dos Años de MURRAY, INC Responsabilidad DEL Propietario Información Para EL PropietarioNormas de seguridad para la operación de la cultivadora ImportanteAntes de usar la unidad Seguridad con el combustibleReparación / Ajustes seguros Almacenamiento seguroCebador Apagado Cebado medio Cebado completo Marcha lenta Marcha rápida CombustibleEnsamblaje Partes Empacadas POR Separado EN LA Caja EnsamblajeCómo Sacar LA Cultivadora DE LA Caja Cómo Ensamblar EL MangoEspaciador Contra- tuerca Tornillo Lista DE Comprobación Conozca SU Cultivadora OperaciónProtección Para LOS Ojos Palanca de control del ahogador SeCómo Operar LA Cultivadora Cómo Usar LA CultivadoraCómo detener la cultivadora Cómo ajustar la profundidadCómo preparar el motor Antes DE Hacer Arrancar EL MotorCómo preparar la mezcla de combustible Proporción de SI. métricoNota No trate de cebar un motor ca- liente o tibio Cómo Hacer Arrancar EL MotorArado pesado más de 4 pulgadas de profundidad Consejos Para CultivarEspecificaciones DEL Producto MantenimientoResponsabilidades DEL Cliente Saque el tornillo del escape de aire Figura De aireDe aceite, el eje de los dientes Bujía Cómo Desmontar Y Montar LOS Dientes Servicio Y AjusteDesmontaje de los dientes Instalación de los dientesEl motor se muestra sin el filtro de aire Cómo Ajustar EL CarburadorMotor AlmacenamientoCultivadora Tabla DE Localizacion DE Averias Problema Causa SoluciónNota Cómo Hacer UN Pedido DE Piezas DE Repuesto