Shindaiwa 89309 manual Additional Problems

Page 15

Troubleshooting Guide (continued)

ADDITIONAL PROBLEMS

What To Check

Poor acceleration.

Possible Cause

Clogged air filter.

Clogged fuel filter.

Lean fuel/air mixture.

Idle speed set too low.

Remedy

Clean or replace the air filter.

Replace the fuel filter.

Consult with an authorized servicing dealer.

Adjust idle. Check Specifications page for correct idle speed.

Engine stops abruptly.

Switch turned off.

Fuel tank empty.

Clogged fuel filter.

Water in the fuel.

Shorted spark plug or loose terminal.

Ignition failure.

Piston seizure.

Reset the switch and re-start.

Refuel. See Fuel section of manual.

Replace fuel filter.

Drain; replace with clean fuel. See Fuel section of manual.

Clean or replace spark plug. Check the Specifications page in this manual for the proper spark plug for your unit. Tighten the terminal.

Replace the ignition unit.

Consult with an authorized servicing dealer

Engine difficult to shut off.

Ground (stop) wire is disconnected or switch is defective

Overheating due to incorrect spark plug

Overheated engine.

Test and replace as required.

Idle engine until cool. Replace the spark plug. Check the Specifications page in this manual for the proper spark plug for your unit.

Idle engine until cool.

Cutting attachment moves at engine idle.

Engine idle too high.

Broken clutch spring or worn clutch spring boss.

Loose attachment holder.

Adjust idle. Check Specifications page for correct idle speed.

Replace spring/shoes as required.

Inspect and re-tighten holders securely.

Attachment will not move.

Shaft not installed in powerhead or gearcase.

Broken shaft. Damaged gearcase.

Inspect and reinstall as required.

Consult with a authorized servicing dealer.

Excessive vibration.

Warped or damaged attachment.

Loose gearcase.

Bent main shaft/worn or damaged bushings.

Inspect and replace attachment as required.

Tighten gearcase securely.

Inspect and replace as necessary.

Engine will not idle down.

Engine idle is set too high.

Engine has air leak.

Adjust idle. Check Specifications page for correct idle speed.

Consult with a authorized servicing dealer.

15

Image 15
Contents HT231 Hedge Trimmer Contents Safety and operation labelsIntroduction Stay Alert SafetySafety devices and labels Work SafelyWipe off any fuel that may have To the unit Spilled Operating the Hedge TrimmerRPM without a load. Doing so could It free of loose vegetation, mud, etcDo not alter this machine or any of its components Product DescriptionMinimize the Risk of Fire Mixing fuelFilling the fuel tank Examples of 501 mixing quantitiesMake sure you have a secure Starting the EngineBefore starting the engine Starting the EngineAdjusting engine idle Stopping the engineOperation Spark Plug MaintenanceGeneral maintenance Daily maintenanceHour maintenance 10 15 hour maintenanceEvery 20 and 100 hours Often in dusty or dirty conditions Throttle free play adjustmentCutter blade adjustment Every 50 hours of operation moreSult your servicing dealer Long Term StorageRemove the spark arrester screen For carbon buildupPossible Cause Troubleshooting GuideEngine does not Start What To CheckEngine is knocking LOW PowerIs the engine overheating? Operate at slower rateAdditional Problems Emission System Warranty Statement NOTAs Remarques Remarques 731-3167, Japan ¡ADVERTENCIA Cortasetos HT231Etiquetas informativas sobre seguridad y funcionamiento IntroducciónContenido Declaraciones De SeguridadEtiquetas de seguridad SeguridadTrabaje con cuidado Mantengase AlertaSeguridad continuación Precauciones de operacionesDe hierba, barro, etc Vshflàfdflrqhv Descripción del ProductoAdvertencia Mezcla de CombustibleLlenando el Tanque de Combustible PrecauciónArranque del motor Antes de usarlaArranque del motor Operación Arranque del motor continuaciónParada del Motor Ajuste de la Marcha MínimaBujía MantenimientoMantenimiento generale SilenciadorMantenimiento continuación Mantenimiento cada 10 horasCada 20 y 100 horas Retire y reemplace el elemento del filtro Mantenimiento cada 50 horasCuchillas Más frecuente en condiciones polvorientas o adversasAlmacenamiento de Largo Plazo Mantenimiento cada 139 horasPosible causa Guia DiagnosticoEL Motor no Arranca Qué revisarDepósitos de carbonilla en el pistón o el silenciador Guia Diagnostico continuaciónBaja Potencia ¿Se sobrecalienta el motor?Otros Problemas Que Está Cubierto Por Esta Garantía Esta garantía es administrada porSus Derechos y Obligaciones de Garantía Cobertura de la Garantía del FabricanteRemarques SP18 SP19 Tualatin, Oregon 97062 USA 11, Ozuka-Nishi Avertissement TAILLE-HAIE À Lame HT231Mise EN Garde Table des MatièresMises en garde Étiquettes au fonctionnement et à la sécuritéSécurité Sécurité au travailÉtiquettes de sécurité Sécurité suite Maintien prévu recommandé Ment serré avant toute utilisationCaractéristiques techniques NomenclatureRéduire les risques d’incendie Mélange de carburantRemplissage du réservoir à carburant Exemples de quantités de mélange de carburant àDémarrage du moteur Avant démarrageDémarrage du moteur Utilisation Démarrage du moteur suiteArrêt du moteur Réglage du ralenti du moteurEntretien Toutes les 20 et 100 heures d’utilisation Entretien suiteEntretien aux 10 heures Toutes les 10 à 15 heures d’utilisationRéglage de la lame Remplacement du filtre à carburantEntretien aux 50 heures Le jeu du levier d’accélérateurEntretien aux 139 heures Remisage à long termePoints à contrôler SolutionGuide de dépannage LE Moteur NE Démarre PASLe moteur cogne Guide de dépannage suitePuissance Insuffisante Le moteur surchauffe-t-il ?Autres Problèmes Couverture de la garantie La présente garantie est administrée parVos droits et obligations en vertu de la garantie Couverture de la garantie des fabricantsFR17 FR18 FR19

89309 specifications

Shindaiwa 89309 is a high-performance trimmer head designed for both professional landscapers and avid gardeners who demand reliability, efficiency, and ease of use. This product stands out in a crowded market due to its innovative engineering and robust construction, making it an essential tool for those who take lawn care seriously.

One of the main features of the Shindaiwa 89309 is its durable design. Constructed from high-quality materials, it is built to withstand the rigors of everyday use while maintaining optimal performance. This means users can tackle tough tasks without the fear of wear and tear, ensuring longevity and durability.

The trimmer head integrates advanced technologies to improve efficiency and ease of operation. One of its most notable technologies is the easy-loading spool system, which allows users to quickly and effortlessly reload the line. This feature significantly reduces downtime, enabling users to get back to their work without hassle.

Additionally, the Shindaiwa 89309 is designed with a dual-line cutting system, which enhances its cutting performance. This system provides a wider cutting path, allowing users to cover more ground in less time. The trimmer head delivers clean and precise cuts, ultimately resulting in a neater finish for lawns and gardens.

Another key characteristic of the Shindaiwa 89309 is its compatibility. The trimmer head works seamlessly with various Shindaiwa machines, allowing for versatility and ease of integration into existing tool collections. This adaptability makes it a practical choice for professionals with multiple pieces of equipment.

Moreover, the Shindaiwa 89309 features an efficient balance that reduces user fatigue. The lightweight design combined with a well-thought-out weight distribution allows for extended periods of use without straining the operator, which is crucial in a demanding work environment.

In summary, the Shindaiwa 89309 trimmer head embodies the perfect blend of durability, efficiency, and user-friendly features. Its advanced technologies, including the easy-loading spool and dual-line cutting system, make it an invaluable tool for achieving pristine landscaping results. Whether for professional use or personal projects, the Shindaiwa 89309 stands out as a reliable choice for trimmers and gardeners alike.