Shindaiwa 89309 manual Troubleshooting Guide, Engine does not Start, What To Check, Possible Cause

Page 13

Troubleshooting Guide

ENGINE DOES NOT START

What To Check

Does the engine crank?

YES

Possible Cause

NO

Faulty recoil starter.

Fluid in the crankcase.

 

 

Internal damage.

Remedy

Consult with an authorized servicing dealer.

NO

Loose spark plug.

Tighten and re-test.

Good compression?

Excess wear on cylinder, piston, rings.

Consult with an authorized servicing dealer.

YES

 

NO

Fuel incorrect, stale, or contaminated;

 

Does the tank contain

mixture incorrect.

fresh fuel of the proper

 

 

 

 

 

 

grade?

 

 

 

 

 

 

 

Refill with fresh, clean unleaded gasoline with a pump octane of 87 or higher mixed with a 2-cycle mixing oil that meets or exceeds ISO-L-EGD and/or JASO FD classified oils at 50:1 gasoline/oil ratio.

YES

Is fuel visible and moving in the return line when priming?

YES

NO

Check for clogged fuel filter and/or vent.

Primer pump functioning incorrectly.

Replace fuel filter or vent as required. Restart.

Consult with an authorized servicing dealer.

Is there spark at the spark plug wire terminal?

YES

Check the spark plug.

The ignition switch is in “O” (OFF) NO position.

Shorted ignition ground. Faulty ignition unit.

If the plug is wet, excess fuel may be in the cylinder.

The plug is fouled or improperly gapped.

The plug is damaged internally or of the wrong size.

Move switch to “I” (ON) position and restart.

Consult with an authorized servicing dealer.

Crank the engine with the plug removed, reinstall the plug, and restart.

Clean and regap the plug. Check the “Specifications” section for the correct plug electrode gap. Restart.

Replace the spark plug. Check the “Specifications” section for the correct plug for your unit. Restart.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents HT231 Hedge Trimmer Safety and operation labels ContentsIntroduction Safety devices and labels SafetyWork Safely Stay AlertRPM without a load. Doing so could Operating the Hedge TrimmerIt free of loose vegetation, mud, etc Wipe off any fuel that may have To the unit SpilledDo not alter this machine or any of its components Product DescriptionFilling the fuel tank Mixing fuelExamples of 501 mixing quantities Minimize the Risk of FireBefore starting the engine Starting the EngineStarting the Engine Make sure you have a secureStopping the engine Adjusting engine idleOperation General maintenance MaintenanceDaily maintenance Spark Plug10 15 hour maintenance Hour maintenanceEvery 20 and 100 hours Cutter blade adjustment Throttle free play adjustmentEvery 50 hours of operation more Often in dusty or dirty conditionsRemove the spark arrester screen Long Term StorageFor carbon buildup Sult your servicing dealerEngine does not Start Troubleshooting GuideWhat To Check Possible CauseIs the engine overheating? LOW PowerOperate at slower rate Engine is knockingAdditional Problems Emission System Warranty Statement NOTAs Remarques Remarques 731-3167, Japan ¡ADVERTENCIA Cortasetos HT231Contenido IntroducciónDeclaraciones De Seguridad Etiquetas informativas sobre seguridad y funcionamientoTrabaje con cuidado SeguridadMantengase Alerta Etiquetas de seguridadPrecauciones de operaciones Seguridad continuaciónDe hierba, barro, etc Vshflàfdflrqhv Descripción del ProductoLlenando el Tanque de Combustible Mezcla de CombustiblePrecaución AdvertenciaAntes de usarla Arranque del motorArranque del motor Parada del Motor Arranque del motor continuaciónAjuste de la Marcha Mínima OperaciónMantenimiento generale MantenimientoSilenciador BujíaMantenimiento cada 10 horas Mantenimiento continuaciónCada 20 y 100 horas Cuchillas Mantenimiento cada 50 horasMás frecuente en condiciones polvorientas o adversas Retire y reemplace el elemento del filtroAlmacenamiento de Largo Plazo Mantenimiento cada 139 horasEL Motor no Arranca Guia DiagnosticoQué revisar Posible causaBaja Potencia Guia Diagnostico continuación¿Se sobrecalienta el motor? Depósitos de carbonilla en el pistón o el silenciadorOtros Problemas Sus Derechos y Obligaciones de Garantía Esta garantía es administrada porCobertura de la Garantía del Fabricante Que Está Cubierto Por Esta GarantíaRemarques SP18 SP19 Tualatin, Oregon 97062 USA 11, Ozuka-Nishi Avertissement TAILLE-HAIE À Lame HT231Mises en garde Table des MatièresÉtiquettes au fonctionnement et à la sécurité Mise EN GardeSécurité au travail SécuritéÉtiquettes de sécurité Sécurité suite Maintien prévu recommandé Ment serré avant toute utilisationCaractéristiques techniques NomenclatureRemplissage du réservoir à carburant Mélange de carburantExemples de quantités de mélange de carburant à Réduire les risques d’incendieAvant démarrage Démarrage du moteurDémarrage du moteur Arrêt du moteur Démarrage du moteur suiteRéglage du ralenti du moteur UtilisationEntretien Entretien aux 10 heures Entretien suiteToutes les 10 à 15 heures d’utilisation Toutes les 20 et 100 heures d’utilisationEntretien aux 50 heures Remplacement du filtre à carburantLe jeu du levier d’accélérateur Réglage de la lameEntretien aux 139 heures Remisage à long termeGuide de dépannage SolutionLE Moteur NE Démarre PAS Points à contrôlerPuissance Insuffisante Guide de dépannage suiteLe moteur surchauffe-t-il ? Le moteur cogneAutres Problèmes Vos droits et obligations en vertu de la garantie La présente garantie est administrée parCouverture de la garantie des fabricants Couverture de la garantieFR17 FR18 FR19

89309 specifications

Shindaiwa 89309 is a high-performance trimmer head designed for both professional landscapers and avid gardeners who demand reliability, efficiency, and ease of use. This product stands out in a crowded market due to its innovative engineering and robust construction, making it an essential tool for those who take lawn care seriously.

One of the main features of the Shindaiwa 89309 is its durable design. Constructed from high-quality materials, it is built to withstand the rigors of everyday use while maintaining optimal performance. This means users can tackle tough tasks without the fear of wear and tear, ensuring longevity and durability.

The trimmer head integrates advanced technologies to improve efficiency and ease of operation. One of its most notable technologies is the easy-loading spool system, which allows users to quickly and effortlessly reload the line. This feature significantly reduces downtime, enabling users to get back to their work without hassle.

Additionally, the Shindaiwa 89309 is designed with a dual-line cutting system, which enhances its cutting performance. This system provides a wider cutting path, allowing users to cover more ground in less time. The trimmer head delivers clean and precise cuts, ultimately resulting in a neater finish for lawns and gardens.

Another key characteristic of the Shindaiwa 89309 is its compatibility. The trimmer head works seamlessly with various Shindaiwa machines, allowing for versatility and ease of integration into existing tool collections. This adaptability makes it a practical choice for professionals with multiple pieces of equipment.

Moreover, the Shindaiwa 89309 features an efficient balance that reduces user fatigue. The lightweight design combined with a well-thought-out weight distribution allows for extended periods of use without straining the operator, which is crucial in a demanding work environment.

In summary, the Shindaiwa 89309 trimmer head embodies the perfect blend of durability, efficiency, and user-friendly features. Its advanced technologies, including the easy-loading spool and dual-line cutting system, make it an invaluable tool for achieving pristine landscaping results. Whether for professional use or personal projects, the Shindaiwa 89309 stands out as a reliable choice for trimmers and gardeners alike.
Top Page Image Contents