B-18APPENDIX B: CLI COMMAND DESCRIPTION

list ip networks Displays all the IP networks you previously defined using the add ip network command. It also lists:

Name - network designation

Prot - always the IP protocol

Int - name of the interface this network runs on

State - state of the network; ENABLED or DISABLED

Type - STATIC or DYNAMIC network

Network Address - address of the IP network

list ip routes Displays all the statically defined IP routes that you previously defined using the add ip route command. It lists:

Destination - IP address that the route resolves to

Prot - LOCAL or RIP

NextHop - address of the gateway used to reach this route

Metric - number of router hops away this route is from the system

If - interface that the route uses

list ipx networks Displays the IPX networks that you previously defined using the add ipx network command. It lists:

Name - designation you assigned this network

Prot - protocol; always IPX

Int - interface each IPX network runs on

State - ENABLED or DISABLED

Type - STATIC or DYNAMIC

Network Address - network address of this IPX network

list ipx routes Displays the IPX routes that you previously defined using the add ipx route command, plus the defined IPX nodes. It lists:

Network Addr - network address of this route

Prot - protocol used to find this route: LOCAL, RIP, STATIC, NLSP, OTHER

NextHopNIC - network address of the next router (the next hop to the destination), or the MAC address for the local IPX nodes (on the LAN)

Gateway - address of the gateway to this network

Metric Ticks - number of hops through routers this network is distant from

list ipx services Displays IPX services. It lists:

Name - name of the IPX service

NetNum - network number that the service is on

Node - name of the IPX node running the service

￿Socket Type - socket number of the service

Page 100
Image 100
3Com 812 manual 18APPENDIX B CLI Command Description