Enter the Peak Cell Rate: | [0] |
|
|
|
|
Enter the Sustainable Cell Rate: (VBR only) | [0] |
|
|
|
|
Enter the Maximum Burst Tolerance: (VBR only) | [0] |
|
|
|
|
The Category of Service and cell rate parameters only affect data transmitted from the OfficeConnect Remote 812 to the remote site (upstream direction). The default value of UBR with a Peak Cell Rate of 0 will attempt to use all available upstream bandwidth when transmitting to the remote site.
The ATM Configuration for VC “name” is now complete.
Network Service The OfficeConnect Remote 812 suppports either PPP, RFC 1483 encapsulation.
Question | Default | Your System |
|
|
|
Select the encapsulation type | [ppp] |
|
|
|
|
PPPParameters (Only applicable if PPP is chosen as the network service.)
You must configure a name and password that will be used during the PPP authentication process.
Question | Default | Your System |
|
|
|
What is the authentication name ? | [name] |
|
|
|
|
What is the authentication password? | [ ] |
|
|
|
|
The authentication name for VC “name” is now complete.
IP Configuration (Only applicable if PPP is chosen as the network service.)
(Network Service PPP)
Network Address Translation (NAT) allows a single
Local and remote IP adresses can be configured in two different ways:
Specified: the IP adress is always a specific address.
Learned: the IP address is learned when the PPP connection is established.
One active VC profile can have its remote router installed as the default router in the OfficeConnect Remote 812’s IP route table.
You can use Routing Information Protocol (RIP) to exchange routing information with other routers on the network.
Question | Default | Your System |
|
|
|
Is IP traffic going to be routed over VC “name”? | [yes] |
|
|
|
|
Do you want to enable IP Network Address Translation (NAT)? | [yes] |
|
|
|
|
Is the remote IP address (S)pecified or (L)earned? | [L] |
|
|
|
|
Enter the IP address of the router across the WAN: (specified | [ ] |
|
only) |
|
|
|
|
|
