A-4APPENDIX A: OFFICECONNECT REMOTE 812 SAMPLE CONFIGURATION

set vc Internet ip enable ipx disable bridging disable set vc Internet network_service ppp

set vc Internet send_name internet-usersend_password 1a2b3c

set vc Internet atm vpi 0 vci 32 category_of_service unspecified pcr 0 set vc Internet address_selection negotiate

set vc Internet local_ip_address 255.255.255.255

set vc Internet nat enable

set vc Internet ip_routing listen

set vc Internet default_route_option enable

enable vc Internet

Remote Site: Corporate In this section, the Remote Site to the Corporate office is defined with the Access identifying name of “corp-net”. IP and IPX are both routed over this remote site

and all other protocols are bridged. The configured network service is RFC 1483 and the remote router address is specified (192.168.1.254). The WAN IPX interface is Unnumbered.

Network Address Translation is disabled on this Remote Site Profile. The ATM virtual channel is VPI 0 and VCI 33 and the Peak Cell Rate is set to the default access rate. This remote site is configured with the following commands:

add vc corp-net

set vc corp-net ip enable ipx enable bridging enable

set vc corp-netnetwork_service rfc_1483

set vc corp-netatm vpi 0 vci 33 category_of_service unspecified pcr 0

set vc corp-netremote_ip_address 192.168.1.254 set vc corp-netlocal_ip_address 0.0.0.0

set vc corp-netnat_option disable

set vc corp-netip_routing both

set vc corp-netipx_address 0 ipx_routing all

enable vc corp-net

Page 82
Image 82
3Com manual Set vc Internet nat enable, 4APPENDIX a Officeconnect Remote 812 Sample Configuration