add ip network <network_name>
CLI Commands
Parameters | Description |
| |
<IP_address > IP Address of the gateway router. | |
|
|
metric | Integer representing how far away the default router is, in “hops” through |
| other routers. Values: |
|
|
address [ip_net_address]
frame [ETHERNET_II SNAP LOOPBACK]
{ interface [eth:1] }
{ enabled [yes] }
Adds an IP network to the list of IP networks available over the specified interface.
Parameters | Description |
|
|
<network_name> | Name of IP network, consisting of up to 32 unique ASCII characters; space |
| must be surrounded by double quotes. |
|
|
address | IP address of the network, in the format nnn.nnn.nnn.nnn, with or without |
| a mask specifier. The Mask Specifier can be ‘A’, ‘B’, ‘C’, or ‘H’, or a numeric |
| value from 8 to 30 that describes the number of one bits in the mask. If you |
| do not specify a mask, the system will generate it for you from the network |
| address. |
|
|
frame | Frame encapsulation to be used on this IP network. The options are: |
| ETHERNET_II, LOOPBACK (for diagnostics), or SNAP. |
|
|
interface | Name of the interface which this IP network will communicate over. The |
| default is the first LAN interface (eth:1). |
|
|
enabled | This optional parameter indicates whether the network is enabled (YES) or |
| disabled (NO). YES is the default. |
|
|
add ip route <ip_net_address>
gateway [gateway_addr]
metric [hop_count]
Adds an entry to the IP routing table. IP packets destined for networks that match this network will be routed to this address. The command list ip routes displays your currently defined routes.
Parameters | Description |
|
|
<net_address> | IP address of the remote network, in the format nnn.nnn.nnn.nnn, with or |
| without a mask specifier. The Mask Specifier can be ‘A’, ‘B’, ‘C’, or ‘H’, or a |
| numeric value from 8 to 30 that describes the number of one bits in the mask. |
| If you do not specify a mask, the system will generate it from the network |
| address. |
|
|
gateway | IP address of gateway used to reach this remote network. |
|
|
metric | An integer representing how far away the route is, in “hops” through other |
| routers. Values are |
|
|
add ipx network | address [ipx_address] |
<network_name> | { interface [eth:1] } |
| |
{ enabled [yes] } | |
frame [ETHERNET_II SNAP DSAP NOVELL_8023] |