CLI QuickVC Setup Script 5-3

Enter the IP mask for the router across the WAN: (specified

[C]

 

only)

 

 

 

 

 

Is the local IP address (S)pecified or (L)earned ?

[L]

 

 

 

 

Enter the local ip address for the WAN connection: (specified

[ ]

 

only)

 

 

 

 

 

Do you want to use “name”’s remote router as the default

[no]

 

gateway ?

 

 

 

 

 

Do you want to run RIP ?

[no]

 

 

 

 

Enter the version of RIP to run: (if applicable)

[v2]

 

 

 

 

The IP configuration for VC “name” is now complete.

IP Configuration Network Address Translation (NAT) allows a single WAN-side IP address to be (Network Service ‘shared’ by multiple LAN-side devices.

RFC1483)

If you choose to run NAT the WAN interface must be Numbered. (i.e., there must be a local WAN-side IP address specified that must be on a different IP network than the LAN-side IP address). See Appendix B of the OfficeConnect Remote 812 ADSL Router User’s Guide for a discussion of Numbered and Unnumbered interfaces.

Local and remote IP adresses can be configured in two different ways:

Specified: the IP adress is always a specific address.

￿Learned: the IP address is learned when the PPP connection is established.

One active VC profile can have its remote router installed as the default router in the OfficeConnect Remote 812’s IP route table.

You can use Routing Information Protocol (RIP) to exchange routing information with other routers on the network.

The IP mask can be specified either as a class (“A”, “B”, or “C”), the number of one bits in the mask, or as an address in the format 255.x.x.x.

Question

Default

Your System

 

 

 

Is IP traffic going to be routed over VC “name” ?

[yes]

 

 

 

 

Do you want to enable IP Network Address Translation (NAT) ?

[yes]

 

 

 

 

Enter the IP address of the router across the WAN:

[ ]

 

 

 

 

Enter the IP mask for the router across the WAN:

[C]

 

 

 

 

Is the WAN interface (U)nnumbered or (N)umbered ?

[N]

 

 

 

 

Enter the local ip address for the WAN connection: (numbered

[ ]

 

only)

 

 

 

 

 

Do you want to use “name”’s remote router as the default

[no]

 

gateway ?

 

 

 

 

 

Do you want to run RIP ?

[no]

 

 

 

 

Enter the version of RIP to run:

[v2]

 

 

 

 

The IP configuration for VC “name” is now complete.

Page 35
Image 35
3Com 812 manual RFC1483, IP configuration for VC name is now complete