CLI Commands
Last Clearing reason: indicates why the call was cleared. Reasons for clearing include, line down, PPP timeout, Authentication error, Network configuration
error, and termination initiated from the local and remote side.
IP, IPX, and Bridge status: current status of each network layer.
Configured - protocol is configured for this VC and the call is being initiated
Not configured - The protocol is disabled on this VC.
Established - Protocol was negoitated successfully and is currently active
on this VC.
Failure - Protocol was configured, but there was a failure in the PPP negotiation while attempting to initiate the network layer.
show command Displays the settings for Command History Depth, and the Current Prompt. You can modify the history depth using set command history, and alter the prompt using set command prompt. Prompts can hold a maximum of 64 characters. For example:
History Depth: 10
Current Prompt: OCR-DSL>
Local Prompt: OCR-DSL>
show configuration Displays a variety of system information including: System Identification, Authentication Remote, Remote Accounting, Interfaces, IP forwarding, IPX Default Gateway, Bridge Spanning Tree, and DNS Domain.
show critical_event Displays where the log files for critical event messages are stored in the FLASH file settings system.
Critical Event Sink - where critical events are logged, default is
Critical Event Backup - where critical events are logged, if the first destination fails, default is
show date Displays the system date, time, and uptime. For example:
System Date: | |
System UpTime: | 2d 08:37:54 |
show dhcp relay Displays the current configuration and counters for both the primary and secondary DHCP relay server.
IP Address - IP address of the DHCP Server.
Max Hops - maximum hops to get to this server.
Status - enabled or disabled.
Request Sent to Server - number of requests sent to server.
