B-2APPENDIX B: CLI COMMAND DESCRIPTION

secondary_address [ip_address]

￿vc_name [vc_name]

Adds the IP Address of a remote DNS Server for the specified Domain Name to the Domain Name Server Table. The first specified server is sent the IP Host Name to be resolved, first without, and then with the default domain name (see set dns for more information about the default domain name). If that server cannot resolve the name, it is sent to the next specified server. If PPP is being used for a wide area connection, the vc_name parameter to specify a remote connection from which the primary and secondary addresses will be learned.

Parameters

Description

 

 

<domain_name>

Domain name. Use * for all domains.

 

 

Status

The status concerning the DNS server.

 

 

primary_address

The primary IP address of the DNS server.

 

 

secondary_address

The secondary IP address of the DNS server.

 

 

vc_name

The VC profile to use for obtaining the DNS addresses

 

 

add filter Adds a filter file name to the filter table. The filter table is a managed list of filter <filter_name> names used by SNMP. A filter file is a text file stored in the FLASH file system, that

you load using TFTP. Add filter also verifies the syntax of the filter file. If syntax verification fails, you’ll receive an error message, and the filter will still be added to the table, but is not usable. You must correct the filter file in a text editor, use TFTP to export the updated file to the system’s FLASH file system, and use the verify filter command to check the filter’s syntax.

Parameters Description

<filter_name>

Designation of a filter file, up to twenty ASCII characters.

 

 

add framed_route vc <name>

ip_route [ip_address]

￿metric [number]

Adds a framed (static) network to the VC profile for WAN connections. This method of creating a static route does not run RIP to learn routes, so you must specify IP route and gateway addresses. See add ip route.

Parameters

Description

 

 

<VC profile name>

VC profile name specified for the framed network. This is limited to 32

 

characters.

 

 

ip_route

IP address of the remote network

 

 

metric

Integer representing how far away the route is, in “hops” from other

 

routers. Values are 1 through 15.

 

 

add ip defaultroute

{ metric [1] }

gateway <IP_address>

￿

 

Defines a default gateway IP router, which acts as the default route for IP packets

 

destined for remote hosts.

Page 84
Image 84
3Com 812 manual Secondaryaddress ipaddress Vcname vcname, Add framedroute vc name Iproute ipaddress Metric number