
CLI Commands B-33
End_time | This field is the end time for the virtual circuit. The expected format is |
| HH:MM:SS. The Seconds field is optional. |
|
|
Header_ | This determines whether you will have no compression on cell headers, or |
compression | if you will use TCP/IP compression on the cell headers transmitted across |
| this vc. |
|
|
idle_timeout | Interval to wait before timing out an inactive connection. Default: 300 |
| seconds. |
|
|
input_filter | Designation of the filter file in FLASH memory to be applied to the input |
| data stream. |
|
|
ip | Sets interface to enable/disable protocol. Default is enable. |
|
|
ip_routing | Sets routing type (RIP packets) accepted on this connection. Options: |
| LISTEN - detects packets destined for system’s nets |
| SEND - routes packets destined for the remote network |
| BOTH - both of the above |
| NONE - ignores all routing packets |
|
|
ip_source_ | When enabled, any packet who’s source IP address falls within the LANs |
validation | IP network will be dropped. |
|
|
ipx | This controls whether to enable or disable IPX for the virtual circuit. The |
| choices are [ENABLE, DISABLE]. |
|
|
ipx_address | This sets the IPX address for the virtual circuit. |
|
|
ipx_routing | This sets the routing type (RIP packets) accepted on this connection. |
| Options are: |
| ALL - listens, sends, and responds RIP packets. |
| LISTEN - detects packets destined for the system’s network. |
| NONE - ignores all routing packets. |
| RESPOND - responds by sending out packets |
| SEND - routes packets destined for the remote network. |
|
|
ipx_wan | This determines if IPX is enabled or disabled for the WAN. Options are |
| [ENABLED, DISABLED]. |
|
|
local_IP_address | IP address of the VC making an IP connection over the WAN interface. |
| There are two special values which may be assigned to the |
| local_IP_address: |
| The local_IP_address should be learned via PPP negotiation |
| (255.255.255.255). |
| The interface is Unnumbered (0.0.0.0). |
|
|
mac_routing | Determines if |
|
|
MTU | Maximum Transfer Unit - largest data packet size allowed. |
|
|
NAT_option | Enable / disable Network Address Translation. |
|
|
NAT_default_ | Default workstation address that incoming IP traffic will get forwarded to |
address | if the demuxing of the network address translation is unresolved. |
|
|
Network_service | Type of network service. Default is PPP. |
|
|
output_filter | Name of filter file in FLASH memory to be applied to output data stream. |
|
|
Password | The password is an alphanumeric string of maximum size 15 characters. |
|
|
remote_IP_address | For a client IP connection, address assigned to the client. |
|
|
Rip | Selects either RIPV1 or RIPV2 for IP RIP. |
rip_authentication Text string used for RIPv2 authentication.