To designate the remote site as the default gateway use the command:

IP Routing 6-7

Configuring IP for the In order to enable IP to be routed to a remote site, you must configure the Remote Site Connection following items in the VC profile associated with the remote site connection.

You must enable IP routing in the profile

You must enter the remote IP address information

You must enter the local IP address information

￿To enable or disable IP routing in a VC profile, use the command:

set vc <vc name>

ip [DISABLE ENABLE]

The remote IP address information consists of the IP address of the router at the other end of the VC connection. This address can be either specified by you, or (if you are using PPP as the Network Service for the connection) it can be learned when the PPP session is established.

To specify the remote IP address, use the command:

set vc <vc name>

￿remote_ip_address <ip address/mask>

To specify that the remote IP address should be learned you can enter 255.255.255.255/H for the <ip address/mask> parameter, or you can use the command:

set vc <vc name>

address_selection negotiate

The IP address associated with the local side of the WAN connection can be specified by you, learned from the remote site (if you are using PPP as the Network Service for the connection), or the interface can be Unnumbered.

To specify the local IP address use the command:

￿set vc <vc name> local_ip_address <ip address>

To specify that the local IP address should be learned you must enter 255.255.255.255 for the <ip address> parameter. To specify that the interface is Unnumbered you must enter 0.0.0.0 for the <ip address> parameter. (See Appendix B of the OfficeConnect Remote 812 ADSL Router User’s Guide for a discussion of Unnumbered interfaces.)

Optionally, you can specify that the remote site should be used as the default gateway.

set vc <vc name>

default_route_option [DISABLE ENABLE]

Page 45
Image 45
3Com 812 manual Remoteipaddress ip address/mask, Addressselection negotiate, Defaultrouteoption Disable Enable