78CHAPTER 5: CONFIGURING THE ROUTER
1Select PPPoE from the protocol
2Enter the IP address and Subnet mask information.
3Enter the user name assigned to you by your ISP in the Username field. And enter the password assigned to you by your ISP in the Password field.
4Select always connected, auto, or manual from the Connect type
5If you want your Router to automatically disconnect from the Internet after a period of inactivity, specify a time in the Idle Time field. (Enter a value of 0 to disable this timeout).
6Enter the MTU value in the MTU field. Do not make changes to this setting, unless your ISP specifically requires a different setting other than 1454.
7IPCP is used by PPP protocol to get one IP address from the PPP server. IPCP subnet function allows you to obtain a subnet (IP address and netmask), rather than an IP address. Check this box to enable the function.
8IPCP Subnet Populate DHCP Server: enable this function to allow the Router to automatically apply the subnet from IPCP subnet to DHCP server. Then LAN clients can get the public IP address assigned by ISP, rather than a private IP address of the local LAN.
9Check the Add Default Route checkbox to set this PVC as the default route, this is used when you configure more than one PVC for the Router.
10Enter the VPI/VCI values. Or click Auto Search to find out the values. VPI (Virtual Path Identifier) and VCI (Virtual Circuit Identifier) numbers should be provided by your ISP.
11Select the Encapsulation, VC MUX or LLC. This information should be provided by your ISP.
