Accton Technology ES4524D, ES4548D, 24/48-Port manual Enabling Lacp on Selected Ports, 46-3, 46-11

Enabling LACP on Selected Ports 17

CLI – The following example sets the load-balance method to source and destination IP address.

Console(config)#port-channel load-balance src-dst-ip		46-3
Console(config)#exit
Console#show port-channel	load-balance	46-11
Source and destination IP	address
Console#

Enabling LACP on Selected Ports

Command Usage

•To avoid creating a loop in the network, be sure you enable LACP before connecting the ports, and also disconnect the ports before disabling LACP.

•If the target switch has also enabled LACP on the connected ports, the trunk will be activated automatically.

•A trunk formed with another switch using LACP will automatically be assigned the next available trunk ID.

	dynamically
	enabled
	}
active	backup
links	link
	}
	configured
	members

•If more than eight ports attached to the same

target switch have LACP enabled, the additional ports will be placed in standby mode, and will only be enabled if one of the active links fails.

•All ports on both ends of an LACP trunk must be configured for full duplex, either by forced mode or auto-negotiation.

•Trunks dynamically established through LACP will also be shown in the Member List on the Trunk Membership menu (see page 17-2).

Command Attributes

•Member List (Current) – Shows configured trunks (Unit, Port).

•New – Includes entry fields for creating new trunks.

-Unit – Stack unit. (Range: Always 1)

-Port – Port identifier. (Range: 1-24/48)

17-5