Accton Technology ES4524D, ES4548D manual Syntax Speed bps no speed, Syntax Stopbits 1

36 Line Commands

speed

This command sets the terminal line’s baud rate. This command sets both the transmit (to terminal) and receive (from terminal) speeds. Use the no form to restore the default setting.

Syntax

speed bps no speed

bps - Baud rate in bits per second.

(Options: 9600, 19200, 38400, 57600, 115200 bps, or auto)

Default Setting

auto

Command Mode

Line Configuration

Command Usage

Set the speed to match the baud rate of the device connected to the serial port. Some baud rates available on devices connected to the port might not be supported. The system indicates if the speed you selected is not supported. If you select the “auto” option, the switch will automatically detect the baud rate configured on the attached terminal, and adjust the speed accordingly.

Example

To specify 57600 bps, enter this command:

Console(config-line)#speed 57600

Console(config-line)#

stopbits

This command sets the number of the stop bits transmitted per byte. Use the no form to restore the default setting.

Syntax

stopbits {1 2}

•1 - One stop bit

•2 - Two stop bits

Default Setting

1 stop bit

Command Mode

Line Configuration

36-8