Accton Technology ES4548D, ES4524D, 24/48-Port manual Lacp system-priority, 32768

lacp system-priority 46

Example

The following shows LACP enabled on ports 10-12. Because LACP has also been enabled on the ports at the other end of the links, the show interfaces status port-channel 1 command shows that Trunk1 has been established.

Console(config)#interface	ethernet 1/10
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface	ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface	ethernet 1/12
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:	1000T
Mac address:	00-30-F1-D4-73-A4
Configuration:
Name:
Port admin:	Up
Speed-duplex:	Auto
Capabilities:	10half, 10full, 100half, 100full, 1000full
Flow control:	Disabled
Port security:	Disabled
Max MAC count:	0
Current status:
Created by:	Lacp
Link status:	Up
Operation speed-duplex:	1000full
Flow control type:	None
Member Ports:	Eth1/10, Eth1/11, Eth1/12,
Console#

lacp system-priority

This command configures a port's LACP system priority. Use the no form to restore the default setting.

Syntax

lacp {actor partner} system-priority priority no lacp {actor partner} system-priority

•actor - The local side an aggregate link.

•partner - The remote side of an aggregate link.

•priority - This priority is used to determine link aggregation group (LAG) membership, and to identify this device to other switches during LAG negotiations. (Range: 0-65535)

Default Setting

32768

46-5