Accton Technology ES4548D manual System Management Commands, Syntax Hostname name no hostname

Chapter 34: System Management Commands

This section describes commands used to configure information that uniquely identifies the switch, and display or configure a variety of other system information.

Table 34-1 System Management Commands

Command	Function	Mode	Page
hostname	Specifies the host name for the switch	GC	34-1
reload	Restarts the system	PE	34-2
switch renumber	Renumbers stack units	PE	34-2
jumbo frame	Enables support for jumbo frames	GC	34-9
show startup-config	Displays the contents of the configuration file (stored in flash	PE	34-3
	memory) that is used to start up the system
show running-config	Displays the configuration data currently in use	PE	34-5
show system	Displays system information	NE, PE	34-7
show users	Shows all active console and Telnet sessions, including user	NE, PE	34-7
	name, idle time, and IP address of Telnet clients
show version	Displays version information for the system	NE, PE	34-8

hostname

This command specifies or modifies the host name for this device. Use the no form to restore the default host name.

Syntax

hostname name no hostname

name - The name of this host. (Maximum length: 255 characters)

Default Setting

None

Command Mode

Global Configuration

Example

Console(config)#hostname RD#1

Console(config)#

34-1