Accton Technology ES4524D, ES4548D, 24/48-Port manual Snmp Commands Function Mode

Chapter 40: SNMP Commands

Controls access to this switch from management stations using the Simple Network Management Protocol (SNMP), as well as the error types sent to trap managers.

SNMP Version 3 also provides security features that cover message integrity, authentication, and encryption; as well as controlling user access to specific areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default), specify read and write access views for the MIB tree, configure SNMP user groups with the required security model (i.e., SNMP v1, v2c or v3) and security level (i.e., authentication and privacy), and then assign SNMP users to these groups, along with their specific authentication and privacy passwords.

Table 40-1 SNMP Commands

Command	Function	Mode	Page
snmp-server	Enables the SNMP agent	GC	40-2
show snmp	Displays the status of SNMP communications	NE, PE	40-2
snmp-server community	Sets up the community access string to permit access to	GC	40-3
	SNMP commands
snmp-server contact	Sets the system contact string	GC	40-4
snmp-server location	Sets the system location string	GC	40-4
snmp-server host	Specifies the recipient of an SNMP notification operation	GC	40-5
snmp-server enable traps	Enables the device to send SNMP traps (i.e., SNMP	GC	40-7
	notifications)
snmp-server engine-id	Sets the SNMP engine ID	GC	40-8
show snmp engine-id	Shows the SNMP engine ID	PE	40-9
snmp-server view	Adds an SNMP view	GC	40-10
show snmp view	Shows the SNMP views	PE	40-11
snmp-server group	Adds an SNMP group, mapping users to views	GC	40-11
show snmp group	Shows the SNMP groups	PE	40-13
snmp-server user	Adds a user to an SNMP group	GC	40-14
show snmp user	Shows the SNMP users	PE	40-15

40-1