Accton Technology 24/48-Port Interface Commands Function Mode, Port-channel channel-idRange

Chapter 45: Interface Commands

These commands are used to display or set communication parameters for an Ethernet port, aggregated link, or VLAN.

Table 45-1 Interface Commands

Command	Function	Mode	Page
interface	Configures an interface type and enters interface configuration	GC	45-1
	mode
description	Adds a description to an interface configuration	IC	45-2
speed-duplex	Configures the speed and duplex operation of a given interface	IC	45-2
	when autonegotiation is disabled
negotiation	Enables autonegotiation of a given interface	IC	45-3
capabilities	Advertises the capabilities of a given interface for use in	IC	45-4
	autonegotiation
flowcontrol	Enables flow control on a given interface	IC	45-5
media-type	Force port type selected for combination ports	IC	45-6
shutdown	Disables an interface	IC	45-6
clear counters	Clears statistics on an interface	PE	45-7
show interfaces status	Displays status for the specified interface	NE, PE	45-8
show interfaces	Displays statistics for the specified interfaces	NE, PE	45-9
counters
show interfaces	Displays the administrative and operational status of an	NE, PE	45-10
switchport	interface

interface

This command configures an interface type and enter interface configuration mode. Use the no form to remove a trunk.

Syntax

interface interface

no interface port-channel channel-id

interface

•ethernet unit/port

-unit - Stack unit. (Range: Always 1)

-port - Port number. (Range: 1-24/48)

•port-channel channel-id(Range: 1-24)

•vlan vlan-id(Range: 1-4093)

Default Setting

None

45-1