Accton Technology 24/48-Port Attaching a Policy Map to Ingress Queues, 56-4, 56-5, 56-6, 56-7

Attaching a Policy Map to Ingress Queues 27

CLI – This example creates a policy map called “rd-policy,” sets the average bandwidth the 1 Mbps, the burst rate to 1522 bps, and the response to reduce the DSCP value for violating packets to 0.

Console(config)#policy-map rd_policy#3		56-4
Console(config-pmap)#class rd_class#3		56-4
Console(config-pmap-c)#set ip dscp 4		56-5
Console(config-pmap-c)#police 100000	1522 exceed-action
set ip dscp 0		56-6
Console(config-pmap-c)#

Attaching a Policy Map to Ingress Queues

This function binds a policy map to the ingress queue of a particular interface.

Command Usage

•You must first define a class map, then define a policy map, and finally bind the service policy to the required interface.

•You can only bind one policy map to an interface.

•The current firmware does not allow you to bind a policy map to an egress queue.

Command Attributes

•Ports – Specifies a port.

•Ingress – Applies the rule to ingress traffic.

•Enabled – Check this to enable a policy map on the specified port.

•Policy Map – Select the appropriate policy map from the scroll-down box.

Web – Click QoS, DiffServ, Service Policy Settings. Check Enabled and choose a Policy Map for a port from the scroll-down box, then click Apply.

Figure 27-3 Service Policy Settings

CLI - This example applies a service policy to an ingress interface.

Console(config)#interface ethernet 1/5	45-1
Console(config-if)#service-policy input rd_policy#3	56-7
Console(config-if)#

27-7