Using the Command Line Interface
31-8
31

To enter the other modes, at the configuration prompt type one of the following

commands. Use the exit or end command to return to the Privileged Exec mode.

For example, you can use the following commands to enter interface configuration

mode, and then return to Privileged Exec mode

Table31-2 Configuration Command Modes

Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 36-1
Access
Control List
access-list ip standard
access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
44-2
44-2
44-12
44-7
44-7
Class Map class-map Console(config-cmap) 56-2
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if)# 45-1
MSTP spanning-tree mst-configuration Console(config-mstp)# 51-7
Policy Map policy-map Console(config-pmap) 56-4
VLAN vlan database Console(config-vlan) 52-5
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#