Configuring IEEE 802.1Q Tunneling 52

Configuring IEEE 802.1Q Tunneling

IEEE 802.1Q tunneling (QinQ tunneling) uses a single Service Provider VLAN (SPVLAN) for customers who have multiple VLANs. Customer VLAN IDs are preserved and traffic from different customers is segregated within the service provider’s network even when they use the same customer-specific VLAN IDs. QinQ tunneling expands VLAN space by using a VLAN-in-VLAN hierarchy, preserving the customer’s original tagged packets, and adding SPVLAN tags to each frame (also called double tagging).

This section describes commands used to configure QinQ tunneling.

Table 52-1 IEEE 802.1Q Tunneling Commands

Command

Function

Mode

Page

 

 

 

 

dot1q-tunnel

Configures the switch to operate in normal mode or QinQ

GC

52-14

system-tunnel-control

mode

 

 

switchport dot1q-tunnel

Configures an interface as a QinQ tunnel port

IC

52-14

mode

 

 

 

switchport dot1q-tunnel tpid

Sets the Tag Protocol Identifier (TPID) value of a tunnel port

IC

52-15

 

 

 

 

show dot1q-tunnel

Displays the configuration of QinQ tunnel ports

PE

52-16

 

 

 

 

show interfaces switchport

Displays port QinQ operational status

PE

45-10

 

 

 

 

General Configuration Guidelines for QinQ

1.Configure the switch to QinQ mode (dot1q-tunnelsystem-tunnel-control, page 52-14).

2.Create a SPVLAN (vlan, page 52-6).

3.Configure the QinQ tunnel access port to dot1Q-tunnel access mode (switchport dot1q-tunnel mode, page 52-14).

4.Set the Tag Protocol Identifier (TPID) value of the tunnel access port. This step is required if the attached client is using a nonstandard 2-byte ethertype to identify 802.1Q tagged frames. The standard ethertype value is 0x8100. (See switchport dot1q-tunnel tpid, page 52-15.)

5.Configure the QinQ tunnel access port to join the SPVLAN as an untagged member (switchport allowed vlan, page 52-11).

6.Configure the SPVLAN ID as the native VID on the QinQ tunnel access port (switchport native vlan, page 52-10).

7.Configure the QinQ tunnel uplink port to dot1Q-tunnel uplink mode (switchport dot1q-tunnel mode, page 52-14).

8.Configure the QinQ tunnel uplink port to join the SPVLAN as a tagged member (switchport allowed vlan, page 52-11).

52-13

Page 473
Image 473
Accton Technology 24/48-Port, ES4548D, ES4524D Ieee 802.1Q Tunneling Commands Function Mode, Dot1q-tunnel, 52-14, 52-15