1 G etting to know your Tra velMa te
24
3Firm ly c o n ne c t the E a sy Link c o m bo driv e ( c o nne c to r to c o n nec to r)
(b) to the c omputer.
To disc onnec t the EasyLink c ombo drive:
1C lic k on the HotIDE ic on ( ) on the Windows taskbar.
2Selec t the stop operation.
A message appears to c onfirm the stop opera tion.
3C lic k on OK.
4Disc onnec t the EasyLink c ombo drive.
5Tuck in the EasyLink combo drive cable connector into its storage
slot.
Note: If the c omputer is on, a nd you disc onnec t the Ea syLink
c ombo d rive without using the HotIDE stop func tion, the
c omputer will ha ng (stop operating norma lly). C onnec t the
Ea syLink c o mbo drive a g a in to so lve this prob le m. It is a dvisa ble
to follow the connect/disconnect procedures discussed above. If
the c omputer is off, you c a n disc onnec t the Ea syLink c ombo drive
at your c onvenienc e.
TM360.book Page 24 Friday, September 21, 2001 5:39 PM