Agilent Technologies Agilent 35670A manual Trigger Delay, Fft

AGILENT 35670A

Supplemental Operator’s Guide

Then set up trigger parameters (for a positive event, positive slope) as follows:

•Press the [TRIGGER SETUP] softkey (F6)

•Press the [CHANNEL LEVEL] softkey (F1)

•Enter 5 then press the [PERCENT (%)] softkey (F4)

•Press the [SLOPE POS NEG] softkey (F5) until POS is highlighted.

Trigger Delay

Both channels should acquire data using the same pre-trigger delay. To set up a

0.01s pre-trigger condition, follow these steps:

•Press the [Trigger] hardkey.

•Press the [TRIGGER SETUP] softkey (F6)

•Press the [ALL CHANNELS] softkey (F8)

•Press the [CHANNEL * DELAY] softkey (F9)

•Enter -.01then press the [S] softkey (F1)

To start the data acquisition,

•Press the yellow [Start] hardkey.

The analyzer should show in highlighted text above the trace:

WAITING FOR CH 1 TRIGGER

Trigger	Arm: Automatic	Waterfall Steps: 15
[FFT]	Chn Level: 5 %	Slope: Positive

Date: 10-03-96 Time: 05:23:00 PM
A: CH1 Time	X:472.168 ms	Y:371.577 mV
500
mV
Real
100
mV
/div
-500
mV
-9.7656ms		489.7461ms
B: CH2 Time	X:472.168 ms	Y:-241.753 mV
500
mV
Real
100
mV
/div
-500
mV
-9.7656ms		489.7461ms

22