Agilent Technologies E2050-90003 manual Installing the Hardware Observe the Power-On Sequence

Installation

Installing the Hardware

Step 5: Observe the Power-On Sequence

nThe Gateway now goes through its power-on, hardware self-test. Verify that the hardware is working properly by looking at the LEDs on the front panel of the Gateway.

nThe green Power LED should now be illuminated and the red Fault LED should be off. One or more of the yellow LAN LEDs may also be flashing. Ignore the LAN LEDs at this time.

nThe red Fault LED is illuminated briefly at power-on to verify its operation. If the Fault LED remains illuminated, a hardware fault was found during the power-on, hardware self-test of the Gateway. Please contact Agilent Technologies for instructions. Service is required only if the Fault LED remains illuminated.

nOnce you have verified that the hardware is working properly (the Gateway’s green Power LED is illuminated), disconnect the standard AC power cord from the power outlet (wall outlet).

Chapter 2 31