Agilent Technologies E2050-90003 manual Telnetcommand value Return, Configuration Methods, Chapter

Configuration

Configuration Methods

The following table lists the configuration values you can set using Telnet. The information following the table explains the syntax you should use and provides reminders to help you to change or set the configuration values correctly.

NOTE

By using the Telnet configuration method, the LAN hardware address (hardware-addr:) value is automatically set to the correct hardware address for this LAN/GPIB Gateway. Do not change the hardware address value via Telnet. Its value in the Telnet configuration table is for information purposes only.

Configuration Value	Telnet Command	Default Value
Hostname	hostname:	E2050
IP Address	ip:	192.0.0.192
Default Subnet Gateway Address	gateway:	0.0.0.0
Subnet Mask	subnet-mask:	0.0.0.0
Syslog Server Address	syslog-svr:	0.0.0.0
BOOTP	bootp:	ON
LAN Timeout	lan-timeout:	0
I/O Timeout	io-timeout:	120
IP Allow List	allow:	* (All allowed)
GPIB Address	hpib-address:	21
GPIB Interface Name	hpib-name:	hpib
GPIB Logical Unit	hpib-unit:	7

For each configuration value to change or set, use the syntax:

Telnet_command: value Return

For example, to set the IP address value of 156.140.222.201 for the Gateway, enter: ip: 156.140.222.201 Return

If you make a mistake, re-enter the correct configuration value you want. To do this, use the same syntax as before to re-enter the value (Telnet_command: value Return).

52 Chapter 3