Allied Telesis 86251-08 manual PCR 03492 Module HTTP, Load Level, PCR Module BGP, Firewall Level

30 Patch Release Note

PCR: 03474 Module: FIREWALL Level: 3

The SMTP proxy did not correctly allow outgoing (private to public) SMTP sessions when the DIRECTION parameter was set to OUT or BOTH in the ADD FIREWALL PROXY command. This issue has been resolved.

PCR: 03475 Module: NTP Level: 3

The PURGE NTP command did not change the UTC offset to the initialised value. This issue has been resolved.

PCR: 03476 Module: IPV6 Level: 3

RIPng was showing routes to interfaces that were DOWN as being UP. This issue has been resolved.

PCR: 03478 Module: PIM, PIM6 Level: 3

The message format for PIM-SM periodic (*,*,RP) Join messages was incorrect when the message contained more than one joined RP address. This issue has been resolved.

PCR: 03484 Module: FIREWALL Level: 3

The firewall was not denying an ICMP packet, even if ICMP Forwarding was disabled when using Standard NAT. This issue has been resolved.

PCR: 03492 Module: HTTP, LOAD Level: 2

Some memory loss occurred when loading a file via HTTP. This issue has been resolved.

PCR: 03494 Module: BGP, FIREWALL Level: 2

If the firewall was enabled when BGP was in use outgoing BGP data packets would have IP header errors and incorrect checksums. This problem has now been fixed.

PCR: 03497 Module: PIM, PIM6 Level: 2

In a network with an alternative path, if the link connected to the interface where a Candidate Rendezvous Point (CRP) advertised its RP candidacy was down, the CRP did not re-advertise its RP candidacy on other available interfaces (the alternative path). This meant that the CRP did not update its PIM routes, which was necessary to re-establish the PIM tree in order for multicast data to flow again. This issue has been resolved.

PCR: 03498 Module: SWI Level: 3

The SHOW SWITCH FDB command showed a number of irrelevant entries.

This issue has been resolved.

PCR: 03502 Module: IPG Level: 3

The ENTRY parameter from the ADD IP FILTER command was not included in the output of the SHOW CONFIG DYNAMIC command. This issue has been resolved.

PCR: 03513 Module: IPG Level: 3

An enhancement allows for the creation of static IGMP group memberships that do not time out. For details on this feature, see “Static IGMP” on page 62.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I