14 Patch Release Note
Patch 86251-08 for Software Release 2.5.1
C613-10356-00 REV I
DHEXPONENTLENGTH parameter in the CREATE ISAKMP POLICY
command was not accepted when creating ISAKMP policies that used IPv6.
This issue has been resolved.
When a NeighbourAdvert message containing an anycast target address was
received, the device incorrectly performed Duplicate Address Detection.
This issue has been resolved.
When IPSec was used with IPv6, an incorrect IP address was displayed in
the output of the SHOW IPSEC SA command. This issue has been resolved.
If a local IP address and remote IP address were not specified in the
CREATE IPSEC POLICY command for IPv6 IPSec, the SET IPSEC POLICY
configuration was shown unnecessarily in the output of the SHOW
CONFIG DYNAMIC=IPSEC command. This issue has been resolved.
MAC address are now deleted from the all the internal tables for ports
where the learn limit has been exceeded.
Features in 86251-06Patch file details are listed in Table3:
Patch 86251-06 includes all issues resolved and enhancements released in
previous patches for Software Release 2.5.1, and the following enhancements:
Support has been added to the Firewall module for RTSP, MMS, BROBA,
and MPEG2.
Support has been added for enabling flow control on half duplex links. The
ENABLE SWITCH PORT command configures the switch chip to send a
jamming signal over a half duplex link in response to congestion. The
following commands configure flow control:
DISABLE SWITCH PORT={port-list|ALL}
PCR: 03938 Module: IKMP Level: 3
PCR: 03939 Module: IPV6 Level: 2
PCR: 03946 Module: IPSEC Level: 3
PCR: 03949 Module: IPSEC Level: 3
PCR: 03952 Module: SWI Level: 3
Table 3: Patch file details for Patch 86251-06.
Base Software Release File 86s-251.rez
Patch Release Date 30-July-2003
Compressed Patch File Name 86251-06.paz
Compressed Patch File Size 895445 bytes
PCR: 02216 Module: FIREWALL Network affecting: No
PCR: 02510 Module: SWI Level: 4