44Patch Release Note

PCR: 02429

Module: IPG

Level: 2

When more than two firewall policies were configured, an unexpected

switch restart sometimes occurred. This issue has been resolved.

 

PCR: 03041

Module: PPP

Level: 1

PPPoE can now be configured on VLAN interfaces in both Client Mode and Access Concentrator (AC) mode. To configure PPPoE in Client Mode, the physical-interface parameter VLANn-servicenamehas been added, where servicename is 1 to 18 characters in length, and for a PPPoE client is usually supplied by the ISP providing the service. To specify that any service name is acceptable, you can use the special service name ANY.

The modified commands using the VLANn-servicenameparameter are:

ADD PPP

CREATE PPP

DELETE PPP

SET PPP

SHOW PPP

The modified commands and parameters are described at the end of this patch release note in PPPoE Client on VLAN Interfaces” on page 73 For all other unmodified parameters and commands refer to the PPP Chapter in your software reference manual.

PCR: 03050

Module: ETH

Level: 3

When an Ethernet port received a MAC Control PAUSE frame it did not stop transmitting packets for a short period of time, as specified in the IEEE 802.3 Ethernet standard. This issue has been resolved.

PCR: 03058

Module: SWI

Level: 4

The state of a port not participating in STP was displayed as disabled, instead of broken. This issue has been resolved.

PCR: 03063

Module: HTTP

Level: 1

When HTTP proxy was configured and HTTP requests were sent in quick succession, a fatal error could occur. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 44
Image 44
Allied Telesis 86251-08 manual ADD PPP Create PPP Delete PPP SET PPP Show PPP