Allied Telesis 86251-08 manual PCR 03239 Module QOS Level, PCR Module SWI, IPG, PIM Level

38 Patch Release Note

PCR: 03234 Module: IPG Level: 3

The PURGE IP command did not remove ENABLE IP IGMP from the configuration. This issue has been resolved.

PCR: 03236 Module: IPG Level: 3

IGMP queries were being sent after IGMP was disabled. This issue has been resolved.

PCR: 03237 Module: IPG Level: 2

RIP Request packets for IPv4 were not being transmitted when the link came up or when the switch restarted. This issue has been resolved.

PCR: 03238 Module: SWI Level: 2

When RIP interfaces were deleted, the IP routes learned through those interfaces were not timing out correctly. Now, all IP routes learned though a RIP interface are removed when the RIP interface is deleted, and no timeouts occur.

PCR: 03239 Module: QOS Level: 2

QoS Traffic Class maximum bandwidth limiting was being overwritten by the port or trunk maximum bandwidth value. This should only happen when the Traffic Class maximum bandwidth has not been set manually with the CREATE QOS TRAFFICCLASS MAXBANDWIDTH parameter. This issue has been resolved.

PCR: 03240 Module: OSPF Level: 2

A fatal error occurred when OSPF was under high load. This issue has been resolved.

PCR: 03245 Module: SWI, IPG, PIM Level: 2

Multicast streams would not commence forwarding immediately due to IGMP packets initiated but not sent while a VLAN was changing from the DOWN to UP state. Also, multicast streams could be received while the VLAN was changing from DOWN to UP, causing a PIM Reverse Path Forwarding unicast route lookup failure. This was due to the unicast route being unusable as the VLAN was still considered down. These issues have been resolved.

PCR: 03247 Module: MVR Level: 4

The Joins and Leaves counters in the SHOW IP MVR COUNTER command output did not count subsequent join or leave requests after the first join or leave. This issue has been resolved.

PCR: 03250 Module: SWI Level: 4

The DELETE SWITCH FILTER command did not work properly when the ENTRY parameter was assigned a range with hyphen (“-”). This issue has been resolved.

PCR: 03252 Module: PIM Level: 3

An assert storm sometimes occurred with PIM-DM. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I