70

SHOW IP IGMP DEBUG

Patch Release Note

SHOW IP IGMP DEBUG

Syntax SHOW IP IGMP DEBUG

Description This command shows the IGMP debugging options that have been set.

Figure 8: Example output from SHOW IP IGMP DEBUG.

IGMP Debugging Information

--------------------------------------------------------------------------------

IGMP Debugging

Enabled

Filter

by

group destination

224.1.2.3

Filter

by

source IP

10.10.1.123

--------------------------------------------------------------------------------

Table 2: Parameters displayed in the output of the SHOW IP IGMP DEBUG command.

Parameter

Meaning

 

 

IGMP Debugging

Whether or not IGMP debugging is enabled; one of

 

"Enabled" or "Disabled".

 

 

Filter by group destination

The Group Destination Address specified by the

 

DESTINATION parameter in the ENABLE IP IGMP DEBUG

 

command. If the parameter was not given, "No" is

 

displayed instead of the IP address.

 

 

Filter by source IP

The source IP address specified by the SOURCEIPADDRESS

 

parameter in the ENABLE IP IGMP DEBUG command. If the

 

parameter was not given, "No" is displayed instead of the

 

IP address.

 

 

Examples To display IGMP debugging information, use the command:

SHOW IP IGMP DEBUG

See Also DISABLE IP IGMP DEBUG

ENABLE IP IGMP DEBUG

Checking the Port Map on Rapier16fi

Switches

This section explains how to check that the port map on your Rapier16fi is correct. If the port map on your Rapier16fi is incorrect, this Note explains how to restore the correct settings.

This information is for Rapier16fi switches only.

The port map on your Rapier16fi will be incorrect if:

it has software release 86s-251, but the 86251-04 patch is not loaded, or

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 70
Image 70
Allied Telesis 86251-08 manual Show IP Igmp Debug, Checking the Port Map on Rapier16fi Switches