Patch 86251-08 For Rapier Series Switches

33

PCR: 03096 Module: VLAN

Level: 2

OSPF and RIP Hello packets were being sent out all trunked ports. Now these Hello packets are only sent out the master port of the trunked group.

PCR: 03097

Module: IPV6

Level: 3

A device could not Telnet to a device outside its own subnet. This issue has been resolved.

PCR: 03098

Module: PIM, DVMRP, IPG

Level: 2

When multicasting in hardware, the switch would not forward packets from a VLAN ingress interface to a non-VLAN interface downstream. This issue has been resolved.

PCR: 03105

Module: FIREWALL

Level: 3

Incorrect handling of TCP sessions, and poor load balancing performance could be caused by TCP virtual balancers not selecting a new resource if required. This issue has been resolved.

PCR: 03109 Module: LOG

Level: 3

A log was only partially created if there was insufficient NVS memory for log creation on the router. A change has been made so that a log is not created if there is insufficient memory, and a warning message is displayed.

PCR: 03110

Module: IPG

Level: 3

An error occurred with the ADD IP MVR command. This issue has been resolved. Also, this command accepted any IP addresses for the GROUP parameter, but now only accepts multicast addresses.

PCR: 03111

Module: FIREWALL

Level: 1

TCP sessions could fail if the public side of the firewall was using Kerberos and the private side had a very slow connection to the firewall. This issue has been resolved.

PCR: 03115

Module: PING

Level: 3

The SHOW CONFIG DYNAMIC=PING command was giving an incorrect port number. This issue has been resolved.

PCR: 03116

Module: FIREWALL

Level: 2

An error sometimes occurred in the firewall module under heavy FTP or

RTSP traffic loads. This issue has been resolved.

PCR: 03117

Module: FIREWALL

Level: 1

The TCP sequence numbers are no longer altered through the firewall when

TCPSETUP is disabled with the DISABLE FIREWALL POLICY command.

PCR: 03119

Module: CLASSIFIER

Level: 4

TCP source and TCP destination ports were swapped when viewed in the

GUI. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 33
Image 33
Allied Telesis 86251-08 manual PCR 03096 Module Vlan Level, PCR Module PIM, DVMRP, IPG Level, PCR 03109 Module LOG Level