Patch | 3 |
PCR: 03684 Module: CORE | Level: 4 |
A fanAndPsRedundantFanTrap message was sent from a Rapier when the RPS (Redundant Power Supply) was turned on or off, even though Rapiers do not monitor the redundant fan status. This issue has been resolved.
PCR: 03726 | Module: TTY, USER | Level: 3 |
The time recorded when a user logged in was overwritten when the same user logged in a second time while the original connection was still active. This meant the SHOW USER command displayed the same time for both connections. This issue has been resolved.
PCR: 03746 | Module: BGP | Level: 2 |
Occasionally a fatal error occurred if BGP debug was disabled. Also, BGP debug messages were sometimes still displayed after BGP debug was disabled. These issues have been resolved.
PCR: 03781 | Module: STP | Level: 2 |
A buffer leak occurred when rapid STP was specified with the SET STP
MODE=RAPID command, but STP had not been enabled with the ENABLE
STP command. This issue has been resolved.
PCR: 03856 | Module: FIRE, UTILITY | Level: 2 |
When a file was copied, only blocks of 1024 bytes were copied successfully. The remainder was discarded. This had two possible consequences. Either a truncated file was created on the destination media, or the device restarted with a fatal error. This issue has been resolved so that files copy correctly.
PCR: 03858 | Module: IP |
This PCR implements RFC 1256 “ICMP Router Discovery Messages”. This enhancement allows the device to advertise its interface IP addresses to local hosts. For details, see “ICMP Router Discovery Advertisements” on page 47.
PCR: 03861 | Module: IPV6 | Level: 2 |
When a connector was plugged into one physical interface, the RIPng request packet was erroneously transmitted from all interfaces on the switch. This issue has been resolved.
PCR: 03873 | Module: IPG | Level: 4 |
The STATIC and INTERFACE options have been removed from the PROTOCOL parameter in the ADD IP ROUTE FILTER and SET IP ROUTE FILTER commands. These parameters were redundant because received static and interface routes are always added to the route table.
PCR: 03893 | Module: FW | Level: 3 |
Reverse enhanced NAT was not working for ICMP packets. This issue has been resolved.
PCR: 03926 | Module: PIM | Level: 2 |
Repeated Assert messages were sent after the prune limit expired. This issue has been resolved. The default dense mode prune hold time has been changed from 60 seconds to 210 seconds.
Patch
