Allied Telesis 86251-08 manual PCR 03205 Module Dhcp Level, PCR 03229 Module Load Level

Patch 86251-08 For Rapier Series Switches 37

PCR: 03205 Module: DHCP Level: 2

The following issues with DHCP have been resolved:

•DHCP assigned an incorrect IP address to clients shifting from a relayed to a non-relayed range. Gateway checks have been added to resolve this issue.

•DHCP clients shifting between relayed ranges were not always recognised, and were occasionally allocated incorrect addresses.

•DHCP offered entries did not time out after a NAK on a bad lease time request.

PCR: 03206 Module: IPG Level: 3

IPv4 filters now behave like IPv6 filters.

PCR: 03208 Module: FIREWALL Level: 2

When the configuration script was created using the CREATE CONFIG command, the GBLIP parameter in the ADD FIREWALL POLICY command was listed twice. This caused the command to fail when the device was restarted. This issue has been resolved.

PCR: 03211 Module: SWI Level: 2

When the MARL table had been fully populated, the addition of another multicast group caused an entry to be deleted, and the new entry was not added. This issue has been resolved so that no more groups can be added when the table is full.

PCR: 03212 Module: IPV6 Level: 3

The TRACE command was not working when using an ipv6 link-local address. This issue has been resolved.

PCR: 03213 Module: IPSEC Level: 3

A memory leak occurred when some IPSEC processes failed. This issue has been resolved.

PCR: 03216 Module: PIM, PIM6 Level: 2

PIM4 and PIM6 were not sending Hello packets if the HELLOINTERVAL was not a multiple of 10. This is set with the ADD PIM INTERFACE, ADD PIM6 INTERFACE, SET PIM INTERFACE, and SET PIM6 INTERFACE commands. This issue has been resolved.

PCR: 03222 Module: PIM, PIM6 Level: 2

If the RP candidate advertising time was set to a non-default value with the ADVINTERVAL parameter in the SET PIM command, the hold time in the message was not being updated correctly. This issue has been resolved.

PCR: 03229 Module: LOAD Level: 3

Zmodem was not naming some loaded files. This issue has been resolved.

PCR: 03232 Module: BGP Level: 3

Values for the KEEPALIVE and HOLDTIME parameters in the ADD BGP PEER and SET BGP PEER commands were not interacting correctly. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I