66

ADD IP IGMP DESTINATION

Patch Release Note

New Commands

ADD IP IGMP DESTINATION

Syntax ADD IP IGMP DESTINATION=ipaddress INTERFACE=interface PORT={ALLport-list}

where:

ipaddress is an existing IGMP group destination address.

interface is the name of the interface over which multicast data is forwarded. This must be a VLAN interface.

port-listis a port number, a range of port numbers (specified as a-b), or a comma separated list of port numbers and/or ranges. Port numbers start at 1 and end at m, where m is the highest numbered Ethernet port, including uplink ports.

Description This command adds additional ports, through which multicast data is forwarded.

The DESTINATION parameter specifies the IP address from where multicast data is forwarded.

The INTERFACE parameter specifies the interface over which multicast data is forwarded. This must be a VLAN interface, e.g. VLAN1.

The static IGMP association identified by the DESTINATION and INTERFACE parameters must already exist.

The PORT parameter specifies the ports through which multicast data is forwarded. If any of the ports specified in the port list are already part of the association, or are not valid ports for the specified interface, an error message is displayed.

A port may belong to several associations if it belongs to several interfaces (i.e. if there are overlapping VLANs). If one of the ports specified in the port list already has a dynamic IGMP host, it will be replaced by the new static entry. If ALL is specified, all ports belonging to that interface will forward multicast data.

Examples To add port 5 to the list of ports through which multicast data for 224.1.2.3 will be forwarded over vlan1, use the command:

ADD IP IGMP DESTINATION=224.1.2.3 INTERFACE=VLAN1 PORT=5

See Also DELETE IP IGMP DESTINATION

SHOW IP IGMP

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 66
Image 66
Allied Telesis 86251-08 manual ADD IP Igmp Destination