Patch | 23 |
PCR: 03720 | Module: STP | Level: 2 |
When changing from RSTP to STP mode, the STPCOMPATIBLE option for the RSTPTYPE parameter incorrectly appeared in the dynamic configuration. Also, when changing from RSTP to STP mode or vice versa, disabled STP ports did not remain in the disabled state. These issues have been resolved.
PCR: 03722 | Module: PPP, VJC | Level: 3 |
Previously, VJC supported 136 interfaces and PPPoE supported 256 PPP interfaces, but the device software supported up to 512 PPP interfaces. This discrepancy sometimes caused a fatal error and prevented PPPoE interfaces with a PPP index greater than 255 from working correctly. This issue has been resolved, so that VJC and PPPoE now fully support 512 PPP interfaces.
PCR: 03723 | Module: BGP | Level: 2 |
BGP routes that were added after a summary aggregate route had been formed were not suppressed. This issue has been resolved: all routes added after summary aggregate route creation are also now suppressed.
The SHOW BGP ROUTE command displayed unselected routes as the "best" route, until they had been processed. This issue has been resolved.
When a single route was deleted from an aggregate route, the aggregate route was deleted, even if it contained other routes. This issue has been resolved.
PCR: 03728 | Module: IPG | Level: 4 |
A field has been added to the SHOW IP command output that displays whether the IP ARP log is enabled or disabled.
PCR: 03733 | Module: IPV6 | Level: 3 |
When an oversize packet (PMTU) was received, an error message was not returned, even when IPv6 flow was enabled. This issue has been resolved.
PCR: 03738 | Module: IPG | Level: 2 |
If a port went down, the port was deleted from the appropriate static IGMP associations but was not added back again when it came back up. Similarly, static IGMP associations were automatically deleted but not added back when IP or IGMP was disabled. These issues have been resolved. You can now create IGMP associations before enabling IGMP, and they will become active when IGMP is enabled.
PCR: 03741 | Module: FIREWALL | Level: 3 |
The maximum number of firewall sessions had decreased since software release
PCR: 03743 | Module: IP | Level: 3 |
If a ping was active and the IP configuration was reset, subsequent pings were sent out the wrong interface. This issue has been resolved.
PCR: 03744 | Module: PING | Level: 3 |
Executing a ping to the IP address 0.0.0.0 did not return an invalid destination address error message. Also, when the TRACE command was executed for local addresses, it timed out after 90 seconds. These issues have been resolved.
Patch
