Patch 86251-08 For Rapier Series Switches

29

PCR: 03456

Module: PIM

Level: 2

A VLAN interface receiving a PIM Prune message on a port stopped forwarding multicast data to that port too early. This could cause multicast data to arrive after a PIM Prune, so an override PIM Join message was not sent, leading to a loss of multicast data. This issue has been resolved.

PCR: 03457

Module: OSPF

Level: 2

Disabling OSPF caused a fatal error if there was a large routing table. This issue has been resolved.

PCR: 03459

Module: IPV6

Level: 2

A fatal error sometimes occurred when packets were forwarded via an IPv6 interface, and IPv6 flows were disabled. This issue has been resolved.

PCR: 03461

Module: IPG

Level: 3

The ENABLE IP MVR DEBUG=ALL command was erroneously shown in the output of the SHOW CONFIG DYNAMIC=IP command. This SHOW output no longer includes the ENABLE IP MVR DEBUG=ALL entry.

PCR: 03462

Module: PIM, PIM6

Level: 3

PIM Graft and Graft-Ackcounters were not incrementing. This issue has been resolved.

PCR: 03465 Module: DHCP

Level: 3

The IPMTU parameter in the ADD DHCP POLICY command was accepting values in the range 0-4294967295. This parameter now accepts values in the correct range of 579-65535.

PCR: 03463

Module: PIM, PIM6

Level: 3

PIM-SM Null register messages did not update the register counter correctly, and did not trigger Register debug messages. This issue has been resolved.

PCR: 03464

Module: PIM, PIM6

Level: 3

PIM-SM Null register messages for non-PIM-SM domain sources did not have the Border bit set. This issue has been resolved.

PCR: 03467

Module: IPG

Level: 3

An invalid message appeared when the PORT parameter was specified for the ADD IP ROUTE command. This issue has been resolved.

PCR: 03471

Module: IPV6

Level: 2

A fatal error sometimes occurred when forwarding traffic over an IPv6 tunnel. This issue has been resolved.

PCR: 03473

Module: PIM, PIM6

Level: 3

The SET LAPD MODE=NONAUTOMATIC command did not change the LAPD mode from automatic to non-automatic. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 29
Image 29
Allied Telesis 86251-08 manual PCR Module PIM Level, PCR 03465 Module Dhcp Level