Allied Telesis 86251-08 manual PCR Module Ospf Network affecting No, PCR Module L2TP Level

Patch 86251-08 For Rapier Series Switches 15

DISABLE SWITCH PORT=port-listFLOW=PAUSE

DISABLE SWITCH PORT=ALL FLOW={JAMMINGPAUSE}[,...]

ENABLE SWITCH PORT={port-listALL}

ENABLE SWITCH PORT=port-listFLOW=PAUSE

ENABLE SWITCH PORT=ALL FLOW={JAMMINGPAUSE}[,...]

SHOW SWITCH PORT[={port-listALL}]

PCR: 03011 Module: OSPF Network affecting: No

When the router priority was changed on a dynamic OSPF interface, the new priority did not appear in the output of the SHOW OSPF NEIGHBOUR command on neighbouring routers. The new priority only showed after the RESET OSPF command was executed on the neighbouring routers. This issue has been resolved.

PCR: 03070 Module: BGP Level: 2

When BGP imported other route types, it would advertise routes that had nexthops of the BGP peers themselves. The BGP peers would reject these routes and close the peering session, thus preventing the exchange of routing information between BGP peers. This issue has been resolved.

PCR: 03072 Module: BGP Level: 4

The Import parameter of the ADD, SET, DELETE and SHOW BGP commands now has an INTERFACE type. INTERFACE routes were previously grouped with STATIC routes.

PCR: 03178 Module: IPSEC Level: 4

An unnecessary check has been removed from the CREATE ISAKMP

POLICY AUTHTYPE=RSASIG command.

PCR: 03264 Module: FIREWALL Level: 4

The event logs for the firewall did not show the correct detail for DOSFLOOD, HOSTSCAN, SYNATTACK and HOSTSCAN. This issue has been resolved.

PCR: 03287 Module: Firewall Level: 2

When the firewall was set to ACTION=NAT, it was allowing inbound traffic, (for example FTP) even though a port was specified for a particular application, (for example Telnet). This issue has been resolved.

PCR: 03310 Module: SWI Level: 3

When the VLAN mirror port was configured as a tagged port, the port did not transmit tagged packets. This issue has been resolved.

PCR: 03315 Module: L2TP Level: 2

The L2TP Framing Type attribute-value pair (19) for virtual tunnels was set to 0 which caused an interoperability problem with a Linux L2TP implementation. This issue has been resolved. The Framing Type attribute- value pair is now set to 1 (synchronous) for virtual tunnels.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I