Allied Telesis 86251-08 PCR Module SWI Level, PCR Module IGP Level, PCR 31001 Module Dhcp Level

Patch 86251-08 For Rapier Series Switches 5

PCR: 03982 Module: FIREWALL Level: 3

The SMTP proxy did not correctly filter sessions where messages were fragmented. This had the potential to prevent the detection of third-party relay attacks. This issue has been resolved.

PCR: 03985 Module: SWI Level: 2

Sometimes on Rapier series switches, a severe multicast or broadcast storm depleted packet buffers, so the switch received packets intermittently. This issue has been resolved.

PCR: 31000 Module: IGP Level: 3

In the output of the SHOW IP IGMP COUNTER command, the outQuery and outTotal counters were always displaying “0”. This issue has been resolved.

PCR: 31001 Module: DHCP Level: 2

When executing the SET DHCP POLICY, DELETE DHCP POLICY and DESTROY DHCP POLICY commands, memory was not de-allocated correctly. This issue has been resolved.

PCR: 31002 Module: UTILITY Level: 2

Sometimes the device rebooted when a severe multicast storm occurred due to a loop in the network. This issue has been resolved.

PCR: 31009 Module: HTTP Level: 3

The server string was not copied correctly into an HTTP file request when loading information from the configuration script. This issue has been resolved.

PCR: 31013 Module: SWI Level: 2

If ports were set to a speed of 100m when creating a switch trunk, the speed could not subsequently be set to 1000m, even if the ports were capable of that speed. This issue has been resolved.

PCR: 31015 Module: STP Level: 2

The PORT and PORTPRIORITY parameters of the STP PORT command were not always updating switch instances on ports that are members of multiple STP instances. This issue has been resolved.

PCR: 31017 Module: NTP Level: 3

The RootDispersion value in NTP packets was negative. RFC 1305 states that only positive values greater than zero are valid. This issue has been resolved.

PCR: 31019 Module: PIM6 Level: 2

The checksum for the PIMv2 Register message for IPv6 was not being calculated correctly. This issue has been resolved.

PCR: 031020 Module: PIM Level: 2

When the switch received a generation ID change message, it was not responding by sending a PIM HELLO message. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I