6

Patch Release Note

PCR: 31028

Module: BGP

Level: 2

BGP did not always send Withdrawn advertisements when a route went down. This issue has been resolved.

PCR: 31040

Module: PIM

Level: 2

When two devices are BSR candidates, and have the same preference set with the SET PIM BSRCANDIDATE PREFERENCE command, the device with the higher IP address was not elected as the candidate. This issue has been resolved.

PCR: 31041

Module: PIM

Level: 3

A Prune message sent to an old RP neighbour was ignored when a new unicast route was learned. This issue has been resolved.

PCR: 31044

Module: SWI

Level: 4

The log message “IGMP Snooping is active, L3FILT is activated” has been changed to “IGMP packet trapping is active, L3FILT is activated”. The revised message is clearer when IGMP is enabled and IGMP snooping is disabled.

PCR: 31052

Module: FIREWALL

Level: 3

The following changes have been made to the ADD FIREWALL POLICY

RULE and SET FIREWALL POLICY RULE commands:

An IP address range for the IP parameter is now only accepted when enhanced NAT is configured.

An IP address range for GBLREMOTE parameter is now only accepted when reverse or reverse-enhanced NAT is configured.

The GBLIP parameter is not accepted for a public interface when enhanced NAT is configured.

PCR: 31058

Module: NTP

Level: 3

When the interval between the NTP server and client exceeded 34 years 9 days and 10 hours, the time set on the client was incorrect. This issue has been resolved.

PCR: 31063

Module: IPG

Level: 2

MVR was not operating if IGMP had not been enabled. This issue has been resolved.

PCR: 31068

Module: STP

Level: 2

A fatal error occurred when the PURGE STP command was executed when STP instances were defined with VLAN members. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 6
Image 6
Allied Telesis 86251-08 manual PCR Module BGP Level