Installing the Hardware
3Power down the system, disconnect the drives from the 7/8000 controller and remove the controller from the system.
4Attach the drives to the 9000 controller, as described earlier in this section.
Finishing Up
After you have installed the controller in the computer and attached appropriate cables to the controller and drives, complete the following steps to complete the hardware installation.
Check your Installation and Close the Case
1Verify that the cables do not interfere with the operation of any other components in the case or block the flow of cooling air.
2Close the case and reconnect the power cables.
Configure your RAID Arrays
Turn to “Configuring Units” on page 27 for information about configuring the RAID arrays.
223ware 9000 Series Serial ATA RAID Controller Installation Guide
