AMCC 9000 manual Leaving Individual Drives as JBODs

Configuring Units

3Tab to OK and press Enter.

After you start your system, you will see multiple volumes available in the operating system: 2 TB each, plus one volume with any remaining storage beyond the multiple of 2TB. (In this release, 3BM does not show individual volumes.)

Leaving Individual Drives as JBODs

By default, if you leave individual drives unconfigured (JBODs), they will not be available to the operating system. If you want to be able to use individual drives, configure them as single-disk units.

If you have JBODs attached to an 8000 controller that you want to use with the 9000 controller, see “Moving Units from an 8000 Controller to a 9000 Controller” on page 23.

483ware 9000 Series Serial ATA RAID Controller Installation Guide